hartmann 10040510 Alarm Brake Disc Lock Instruction Manual

: June 5, 2024
: hartmann

Table of Contents

hartmann 10040510 Alarm Brake Disc Lock
ALARM BRAKE DISC LOCK
General information
Safety
Technical data
Cleaning and care
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

hartmann 10040510 Alarm Brake Disc Lock

hartmann-
PRODUCT

ALARM BRAKE DISC LOCK

What’s included

Brake disk lock with 5 mm locking pin
Spiral memory cable
Carry pouch
Key
Tool (not shown)
CR2 lithium battery (not shown)
Brake disk lock with 10 mm locking pin
Carry pouch
Key
Tool (not shown)
CR2 lithium battery (not shown)

General information

Reading and keeping the instructions for use
These instructions for use apply exclusively to the aforementioned Hartmann Alarm Brake Disc (for short: lock). They contain important information on safety and handling. Read these instructions carefully, in particular the safety instructions, before using the lock. Failure to adhere to instructions can cause damage to the lock itself or to the vehicle. Keep these instructions for future reference. If you pass the lock on to a third party, you must also hand over these instructions.
The instructions for use are based on the standards and regulations applicable in the European Union and reflect current state-of-the-art technology. If abroad, you should also observe any country-specific guidelines and laws.

Explanation of symbols
The following symbols and signal words are used in these instructions for use, on the lock or on the packaging.

WARNING This symbol/signal word indicates a hazard with a medium risk level which, if not avoided, may result in death or serious injury.

CAUTION This symbol/signal word indicates a hazard with a low-risk level which, if not avoided, may result in minor or moderate injury.

IMPORTANT This signal word warns of possible material damage .

This symbol gives you useful additional information about assembly or usage.

Declaration of conformity (see Section “Declaration of conformity”): Products marked with this symbol comply with all applicable Community regulations of the European Economic Area.

This symbol indicates that the packaging and product can be recycled.

Old electrical devices must not be disposed of with household waste.

Used batteries must not be disposed of with household waste.

Safety

Intended use
The lock is used as an anti-theft device for your motorcycle. In case of vibrations and/or a change in the position of the vehicle or the lock, a loud beep of up to 110 dB sounds, thus drawing attention. For reasons of both safety and official approval (CE), the product must not be converted and/or modified.
The lock must only be used as described in these instructions for use. Any other use is considered improper use and may result in damage or injury. The manufacturer and supplier accept no liability for damage caused by improper or incorrect use.

WARNING!
The danger for children and persons with reduced physical, sensory or mental abilities (e.g. partially disabled persons, elderly persons with reduced physical and mental abilities) or lack of experience and knowledge!

Do not leave packaging material lying around. It could become a dangerous toy for children. Dispose of any packaging that is no longer required, or keep it out of the reach of children. Risk of asphyxiation!
Do not let children or persons with restricted physical, sensory or mental abilities or lack of experience and lack of knowledge use electrical devices or play with them without supervision.
This device is not designed for use by persons (including children) who have reduced physical, sensory or mental abilities, or those with little experience or knowledge, unless they are supervised by a person responsible for their safety during use of the device.

CAUTION!

Risk of injury!

Never hold the lock to your ear when the beep has been triggered. The loud sound can cause hearing damage.

IMPORTANT!

Risk of damage!

Due to the weight of the lock, it must not be installed on the external parts of the frame with the storage bag. The hook-and-loop fastening could open, the lock could fall out and enter into the following or oncoming traffic, causing accidents.
Never immerse the lock in water. The electronics are splash-proof but will not withstand being fully immersed.

How to use
First check whether the lock is suitable for the respective vehicle, brake disc, throat depth, throat height, and locking pin diameter. To do so, you can check both on the front and the rear brake disc. Then, unlock the locking pin with one of the two supplied keys and remove the key again. Now, push the brake disc lock onto the brake disc. A beep sounds. Then, push the locking pin down with the cylinder lock. The lock has been locked and the alarm is activated. If the lock is not locked within 15 seconds, an alarm sounds. Once the lock has been locked, you have approximately 15 seconds of time to make positional changes. Any vibrations after the 15 seconds will cause an acoustic alarm. This recurring acoustic alarm runs for approximately 7 seconds and then changes to a siren sound which lasts 15 seconds.
If there are no more vibrations or changes in position, the siren stops. The alarm sounds again if there are further or new vibrations or a change in position. The alarm is stopped immediately when the lock is opened and removed from the brake disc.

Technical data

Weight: 370 g Battery: CR2 lithium battery
750 g CR2 lithium battery

Storage

The Hartmann Alarm Brake Disc Lock must be stored in its storage bag, in a room that is protected from the elements. The temperature should be between -10°C and +50°C with a max. humidity of 80% (non-condensing). Remove the battery if you do not intend to use the lock for a prolonged period. Store in the vehicle, underneath the seat, or in another lockable storage facility.

Cleaning and care

Cleaning
Use a soft cloth and a little mild cleaning agent to clean the housing. Harsh solvents, such as thinner or petroleum ether, must not be used, nor must scouring agents or sharp tools, as these will damage the surface. Do not under any circumstances clean with copious amounts of water – at most a slightly damp cloth.

Changing the battery

Unfasten the screw(s) with the supplied screwdriver from below and remove the upper cover. Then, remove the silicone cover and replace the battery with a new battery with the same specification (CR2). Then, fit the covers again and firmly tighten the screws again.

Warranty
This product comes with a statutory two-year warranty. The warranty period begins on the date of purchase. The warranty does not cover normal wear and tear, use for anything other than the intended purpose, damage caused by an accident or by modifications or attempted repairs by unauthorized persons, or products that have been modified technically.

CE marking and conformity
Detlev Louis Motorrad-Vertriebsgesellschaft mbH hereby declares that this alarm lock complies with the basic requirements and the other applicable conditions of the Directives 2014/30/EU and 2011/65/EU.

Disposal
Dispose of packaging material and the product itself in accordance with applicable local regulations.

Used electrical devices must not be disposed of with household waste!

In the event that the Hartmann Alarm Brake Disc Lock is not going to be used again, every consumer is legally obliged to take old devices to an appropriate collection point to dispose of them separately from household waste. This ensures that old devices are recycled professionally and negative effects on the environment are prevented. For this reason, electrical devices are marked with the symbol shown here.

Batteries must not be disposed of with household waste!

As a consumer, you are required by law to take all batteries, regardless of whether or not they contain harmful substances*, to a collection point in your municipality/district or to a retailer so that they can be disposed of in an environmentally friendly manner. marked with: Cd = cadmium, Hg = mercury, Pb = lead

Questions about the product
If you have any questions about the product and/or these instructions, please contact our Service Centre by e-mail at: service@louis.eu before using the product for the first time. We will help you as quickly as possible. This is the best way to ensure that the product is used correctly.