Shenzhen Yujinhao Technology H15 3-In-1 Fast Wireless Charger User Manual

June 5, 2024
Shenzhen Yujinhao Technology

Shenzhen Yujinhao Technology H15 3-In-1 Fast Wireless Charger

Notice: To ensure charging 3 devices safely and efficiently, you must use 9V/2A adapter and quick charge cable, if including 15W fast charging phones, you must use 9V/2.7A or 12V/2A adapter
and quick charge cable (if not use the appropriate adapter and quick charge cable, the charger may not charge phone fast, or may not charge 3 devices simultaneously, or may even damage the charger

Product Introduction

The 3-in-l wireless charger, a compact charging house, powered from only one outlet, can ch­arge 3 devices simultaneously. When charge your mobile phone, apple watches, and your Air­Pods 2 or AirPods Pm just put them on, wireless charging will automatically start, all this will make our desk dean and tidy, and make your life easier.
The charger is so space-saving designed that can help you integrate your mobile phone’s intelligent life very well, especially for Apple users. Besides, it is fashion that the light ring is so shining and has a breathing effect showing the charging state, if you want to turn off or turn on the light, just touch the touch-sensitive key.

Product Appearance

Shenzhen-Yujinhao-Technology-Fast Wireless-
Charger-1

Operation steps

  1. Connect the charger to 9V/2A, 9V/2.7A or 12V/2A adapter through a type-C quick charge cable to Switch on the power,
  2. Put your phone on and charge;
  3. Put the apple watch on and suck it up to charge (roll the watchband to minimize to charge better);
  4. Put your earphone case on and charge

LED light ring instructions

  • * Greenlight is on: Standby mode or not charging the phone
    • Blue and Greenlight flash: A foreign body is detected or is misaligned (the phone ch automatically stop)
    • Blue light is breathing: Wireless charging of the phone

Charging Schematic DiagramShenzhen-Yujinhao-Technology-Fast Wireless-
Charger-2

Applicable Devices

  1. Smart Phone:

    • Apple: iPhone 11,11 Pro,11 Pro Max, Xs, Xs Max, XRX,8, 8 Plus,12 mini., 12, 12pro, 12promax;
    • Samsung: Galaxy S: 20 56, 20+ 56, 20 Ultra 56, 10,10+,10e,9,9+,8,8+,7,7 edge,6,6 edge, 6edget,669209,6 Active;
    • Galaxy Note: 10,10e, 10+,9,8,7,6,5;
    • Huawei: P30 Pro; Mate:30 56,30 Pro 5G,30,30 Pro, 30 RS,20 Pro,20 RS, RS;
    • Xiaomi: 10 10 Pro. 9,9Pro Mix 3, Mix 2s;
    • Including other devices with wireless charging receiver built-in; other some devices need to add a wireless charging receiver
      (Note: All devices must meet the Qi standard).
  2. SmartWatch:
    Apple: iWatch S1,S2,S3, S4,S5, S6, S7.

  3. TWS Bluetooth earphones:
    Apple AirPods 2, Pro;

Product Specification

  • Input: 9V/2A,9V/2.7A or 12V/2A(must use 9V/2.7A or 12V/2A when charging 3 devices including 15W charging phone)
  • Phone Output: 15W/10W/7.5W/5W
  • Watch Output: 2.5W (Apple iWatch S1,$2,S3,S4,S5,S6)
  • Earphone Output: 5W (TWS Earphone: Apple AirPods 2, AirPods Pro)
  • Input Interface:Type-C port
  • Transmission Distance(Phone):8mm
  • Conversion Rate(Phone):273%
  • Product Size: 120x121x65mm

Accessories List

  • Wireless Charger’1,
  • Type-C quick charge cable’1,
  • User manual’1

Attention

  1. Please keep the charger away from water or other liquid;
  2. If you need to clean the charger,please make sure it is not switched on the power,
  3. Using Environment temperature remains 0-45°C.

FCC Warning Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in  a residential installation.  This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful  interference  to  radio or  television  reception,  which  can  be  determined  by  turning  the equipment off and on, the user is encouraged to try to  correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment should be installed and operated with a minimum distance of 20cm from the radiator of your body. This
device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals