DVB-T2 HEVC H.265 High Definition Digital Terrestrial Receiver User Guide
- June 3, 2024
- Terrestrial
Table of Contents
DVB-T2 HEVC H.265 High Definition Digital Terrestrial Receiver
Packing list
Functional Port
Upgrade to DVB-T2
Attention
- Place the IR Reviver in front of your TV Not behind it
- Insert 2 AAA batteries (not included) into your remote
DVB Remote Control
- POWER: turn ON/OFF the DVB device
TV Control
- POWER: turn ON/OFF the TV
- SET: auto-learning setting
MEDIA Control
- Show the REC media via the USB device
- Switch 720P or 1080P
- Switch 16:9 or 4:3
- Book listing control
- Show the subtitles (if available)
- Skips to the previous channel
MENU Control
- Electronic guide (if available)
- Info of the channel
- MENU: open the main menu
- EXIT: Exit from a menu
MORE Control
- AUDIO: selects the language of the channel
- TTX: teletext ( if available)
- FAV: creates and shows the list of
- PAGE: navigate inside the menu
- CHANNEL Control:
- TV/RADIO: switch TV or Radio channel
Remote Auto -learning Set
Only these 4 keys of DVB remote can be learned,
All these keys can be set up via steps 1~5
Troubleshooting
| Problem | Possible cause | Solutions |
|---|---|---|
| The front panel display does not turn on | Lack of tension | Make sure the power |
cord is properly inserted into a powered outlet Verify that the switch is
turned on
No image or sound| The cables connecting the TV and the decoder are not
connected correctly| Check that the output signal cable is well connected
(SCART or HDMI). Also check the antenna cable.
TV mode is incorrect| Make sure you have selected the correct input signal on
the TV (SOURCE or INPUT key on the TV remote control)
Incorrect video definition| Press V-FORMAT on the remote control and select a
video resolution that allows correct viewing
Intermittent t picture and audio| Insufficient signal strength| Check that the
antenna cable is well connected, and that the quality of the video signal is
adequate.
Electrical interference| Check that the antenna cable is completely shielded
No audio| The receiver or TV is in silent mode| Disable silent mode using the
MUTE button
Volume level too low| Check that the volume level of the set-top box and
television are adequate
Audio CODEC is not supported| While watching multimedia content, audio
encoding may not be supported (while video encoding may be) and movies may
appear without audio. The file is not completely readable.
Remote control not working| Batteries not inserted| Insert the batteries into
the remote control
Low battery| Replace the batteries
Polarity reversal of batteries| Check that the batteries have been inserted
according to their correct polarity, as indicated on the bottom of the battery
compartment.
The remote control is out of its operating range| Approach and point the
remote control directly at the appliance.
Media files on the USB stick are not played| The files are not of the
supported format| Only some formats are supported
The compression codec is not supported| Only some codecs are supported
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>