IKEA Bemoeta Wall Mounted Extractor Hood Stainless Steel Instruction Manual

: June 5, 2024
: Ikea

IKEA Bemoeta Wall Mounted Extractor Hood Stainless Steel Instruction

Manual

Safety information

For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance.

The wire connection has to be done by specialized technician.

The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
The minimum safety distance between the cooker top and the extractor hood is: for electrical hob 500mm and for gas hob 500mm.
If the instructions for installation for the gas hob specify a greater distance, this must be respected.
Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
For Class I appliances, check that the domestic power supply guarantees adequate earthing.
Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible.
Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).
If the extractor is used in conjunction with non-electrical appliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood.
The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
If the supply cord is damaged, it must be replaced from the manufacturer or its service agent.
Connect the plug to a socket complying with current regulations, located in an accessible place.
With regards to the technical and safety measures to be adopted for fume discharging it is importat to closely follow the regulations provided by the local authorities.
WARNING: Before installing the Hood, remove the protective films.
Use only screws and small parts in support of the hood.
WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards.
Connect the hood to the power net by using a bipolar switch having a contact gap of at least 3 mm.
Do not look directly at the light through optical devices (binoculars, magnifying glasses…).
Do not flambè under the range hood; risk of fire.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
Children should be supervised to ensure that they do not play with the appliance.
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
Accessible parts may become hot when used with cooking appliances.
Clean and/or replace the Filters after the specified time period (Fire hazard).
There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room)
Kitchen hoods and other cooking fume extractors can affect the safe operation of appliances which burn gas or other fuels (including those in other rooms) due to the backflow of combustion gases. These gases can cause carbon monoxide poisoning. After installing a kitchen extractor hood or any other cooking fume extractor, make sure that the gas appliances are tested by a certified technician to guarantee
that there is no backflow of combustion gases.

Use

Switch off or unplug the appliance from the mains supply before carrying out any maintenance work.
The top of the hood must not to be used as a shelf.
The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
Never use the hood for purposes other than for which it has been designed.
Never leave high naked flames under the hood when it is in operation.
Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.

Installation modes

The hood has been designed to be installed and used either as a “Exhaust mode”, or as a “Recirculation mode”.
Exhaust mode (see symbol in installation booklet)
Cooking steam is sucked and channelled outside the house through a discharge duct (not supplied), fitted to the hood steam outlet.
Ensure that the discharge duct is correctly fitted to the air outlet, unit using an appropriate connection system.

Recirculation mode (see symbol in installation booklet)
The air is filtered through one or more the charcoal filters, and then resent into room. Important: Ensure appropriate air
circulation around the hood. Important: If the hood is supplied without charcoal filters and installed on recirculation mode, these must be fitted before the hood can be used. Filters are available in shops.
The hood should be installed away from particularly dirty areas, windows, doors and heat sources.
The accessories for wall fixing are not included because wall made of different materials require different types of fixing accessories. Use fixing systems suitable for the walls of your home and the weight of the appliance. For more details, contact a specialized dealer. Keep this booklet for future consultation.

Filter Alarm

The Allarm for grease filter is Active on the Hood as default, for the Reset check control panel.
The Allarm for long life charcoal filter can be Actived as per procedure on Control Panel.
When the filter alarm is activated, the following messages will appear over time: Grease filter alarm must be cleaned:
“A” key flashes once per second. For maintenance see paragraph Care and cleaning.
Long Life charcoal filter alarm must be cleaned: “A” key flashes twice per second. For maintenance see paragraph Care and cleaning.
Once the filters have been regenerated reset the alarm signal (see paragraph Control Panel).

Product description

Upper chimney
Lower chimney
Hood body
LED Lighting
Grease filter
Control panel

Control Panel

BUTTON	FUNCTION

A =
Speed| ****

Turn the motor on/off at speed one. Turn off each speed.

B = Speed

| Turn the motor on at speed two / Activate charcoal filter alarm
Pres and hold the button for approximately 2 seconds, with all the loads turned off (Motor+Lights), to turn the Activated Charcoal Filter alarm on. LED (A) flashes twice to confirm.

To Deactivated Charcoal Filter alarm off, press the button again and hold for at least 2 seconds.The relevant

LED flashes once (A). Only for recirculation mode. (please refer to page 7)

C = Speed

| Turn the Motor on at speed three / Reset alarm grease and charcoal filter saturation
Pres and hold the button for approximately 2 seconds, with all the loads turned off (Motor+Lights), to reset the grease and charcoal filter saturation alarm. LED (A) flashes three times.
D = Speed| Turn the motor on at Booster speed.

This speed is timed to run for 6 minutes. At the end of this time, the system returns automatically to the speed that was set before. If it is activated with the motor turned off, it will switch to OFF at the end of the time. To deactivate it, press button D or press button A

E = Light| Pres briefly: Turn the lighting system on and off at maximum intensity.

Pres and hold to change the lighting intensity up or down.

General hints

Switch ON the hood at minimum speed when you start cooking and keep it running for few minutes after cooking is finished.
Increase the speed only in case of large amount of smoke and vapour and use boost speed(s) only in extreme situations.
Replace the charcoal filter(s) when necessary to maintain a good odour reduction efficiency.
Clean the grease filter(s) when necessary to maintain a good grease filter efficiency.
Use the maximum diameter of the ducting system indicated in this manual to optimize efficiency and minimize noise.

Care and cleaning

Switch off or unplug the appliance rom the mains supply before carrying out any maintenance work.
IMPORTANT Clean the hood using a damp cloth and a neutral liquid detergent.

Long Life Charcoal Filter

The anti-odour Filter can be washed and regenerated every 3-4 months (or more frequently if the hood is subject to intensive use), up to a Max. of 8 regeneration
cycles (in case of particularly intensive use it is recommended that you do not exceed 5 cycles).

Grease Filters

Clean or replace the filters continuously according to below time intervals, to maintain good performance of the hood and to prevent a potential fire hazard, caused by excessive grease build-up.
The grease filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher.

Replacing the lamps

For Replacement please contact an Authorized Service Center.

What to do if…

If there is a fault, first try to find a solution to the problem yourself. If you cannot find a solution to the problem yourself, contact an authorized service center.

If you operated the appliance wrongly, or the installation was not carried out according to the Assembly instructions, the visit from the Authorized Service Centre technician may not take place free of charge, even during the warranty period.

PROBLEM	POSSIBLE CAUSE	SOLUTION
Appliance not stable.	The appliance is not correctly installed.	Follow the

Installation instruction enclosed to the ap- pliance.
Appliance is not in horizontal position.| The appliance is not correctly installed.| Follow the Installation instruction enclosed to the ap- pliance.
Performance in terms of oil capture are not satisfying.| Oil and grease on metal filters or charcoal filters.| Follow the cleaning frequency of filters as described in

the user manual.

Appliance does not work.

| The appliance is not correctly con- nected.| Verify that the main cable is connected to the motor group or the plug is connected to the socket.

The light does not work.

|

The LED is broken.

|

For replacement, contact the Authorized Service Centre.

Noise of hood is higher than customer expectation.

| Air outlet diameter in the wall is too small, causing a pressure drop and an increase in motor speed.| Follow the Installation instruction enclosed to the ap- pliance.

Product is installed in recirculation mode.

| Product in recirculation mode(and using a charcoal filter) will generate an higher noise than a product in extration mode.

More than one bend in the ventilation duct.

| If the exhaust system in the building has multiple bend in or a long distance, this can increase the noise of the product.

Button A light flashing once per

second.

|

Grease filter alarm.

| Please clean grease filter and reset alarm. Refer to care and cleaning guide for maintenance and control panel guide to reset the filter alarm.

Button A lights flashing twice per

second.

|

Charcoal filter alarm.

| Charcoal filter alarm. Please clean charcoal filter and

reset alarm. Refer to care and cleaning guide

for maintenance and control panel guide to reset the

filter alarm.

Before contacting the Authorized Service Centre:
Switch the appliance on again to see if the problem has disappeared. If not, switch it off again and repeat the operation after an hour.
If your appliance still does not work properly after carrying out the checks listed in the troubleshooting guide and switching the appliance on again, contact the Authorized Service

Centre, clearly explaining the problem and specifying:

the type of fault;
the model;
the type and serial number of the appliance (given on the rating plate).

Technical Data

	Unit	Value
Product Type		Wall mounted hood

Dimensions

| Width| mm| 698
Depth| mm| 381
Exhaust Height min/max| mm| 815/1065
Recirculating Height min/max| mm| 912/1185
Airflow max – Exhaust| m3/h| 380
Noise max – Exhaust| dBA| 60
Airflow max – Recirculating| m3/h| 365
Noise max – Recirculating| dBA| 78
Total Power| W| 276

Lamps info

Maximum speed (boost excluded).

This appliance has been designed, manufactured and marketed in compliance with the E.E.C. Directives.
The technical information is situated in the rating plate on the internal side of the appliance.

Product Information according to EU n°66/2014

| ****

Unit

| ****

Value

---|---|---

Model identifier

| | BEMOTA 103.923.33
Annual Energy Consumption| kWh/a| 34,8
Time increase factor| | 0,6
Fluid Dynamic Efficiency| | 37,6
Energy Efficiency Index| | 36,6
Measured air flow rate at best efficiency point| m3/h| 410
Measured air pressure at best efficiency point| Pa| 459
Maximum air flow| m3/h| 700
Measured electric power input at best efficiency point| W| 139,0
Nominal power of the lighting system| W| 6,0
Average illumination of the lighting system on the cooking surface| lux| 350
Measured power consumption in standby mode| W| N/A
Measured power consumption off mode| W| 0,49

Sound power level at maximum speed (boost excluded)

| ****

dBA

| ****

60

Normative references:

EN/IEC 61591
EN/IEC 60704-1
EN/IEC 60704-2-13
EN/IEC 60704-3
EN 50564

Energy saving

The appliance contains features which help you save energy during everyday cooking.

Environment concerns

Maintenance

The symbol __on the product or on its packaging indicates that this product may not be treated as household

Instead it shall be handed over to the ap- plicable collection point for the recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environ- ment and human health, which could otherwise be caused by inappropriate waste handling of this product.
For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Packaging materials

The materials with the symbol are re- cyclable. Dispose the packaging in suitable collection containers to recycle it.

Maintenance

Do you need extra help?

For any additional questions not related to After Sales of your appliances, like clarifications on installation of the IKEA appliance in the dedicated IKEA kitchen furniture or for clarification on functions of the IKEA
appliances, please contact your nearest IKEA Customer Support Centre, the number is available on www.IKEA.com. We recommend you read the appliance docu- mentation carefully before contacting us.
Read about our guarantee terms on www.ikea.com.

For requests under this guarantee, do not hesi- tate to contact the IKEA appointed Authorized Service Centre.
See the relative national phone numbers on the next page.
For quicker service, always refer to the IKEA article number (8-digit code) and the 12-digit service number found on the rating plate of your appliance.

SAVE THE SALES RECEIPT