Shenzhen Bluecon Technology BCR2 Automatic Clamp Wireless Car Charger User Guide

Shenzhen Bluecon Technology BCR2 Automatic Clamp Wireless Car Charger

FEATURES

• Compatible with all Qi-enabled devices for fast wireless charging, including iPhones and Galaxy/Android devices
• Clips easily to your car air conditioner vent
• Rotates easily for horizontal or vertical viewing
• LED indicator light
• Overload protection keeps your device safe
• Overheat protection for additional safety

IDENTIFICATION OF PARTS

1.  Aufomaticretracfable arms
2.  Intelligent sensing area
3.  Phone cradle
4.  Touchsensor
5.  Air vent clip
6.  LED status indicator
7. USB port
8.  USB power cable (notshown)

INSTALLING THE MOUNT

1.  Place the tightening ring over the vent clip balljoint.
2. Place the ball joint into the socket on the back of the car mount.
3.  Screwthe clip ring overthe socket until the mount is securely attached to the vent clip.
4.  Squeeze the vent clip button until the clamp opens.
5.  Clamp the mount onto your car air conditioner vent.
6. Adjust the mount angle by loosening the ball joint, there-tighten the clip ing
7.  Connect the USB power cord to the USB-C port of the device.
8.  Plug the other end of the power cord in to your car’s USB portor car chargin9 adapter (car charging adapter not included).
9.  The LED indicator light will be blue when the device is ready fo charge your Qi-enabled phone.

CHARGING YOUR DEVICE

1.  Hold your phone 2″ to7″ from the device. The arms will automatically open. Rest yourphone in the phone cradle as the arms automatically close to clamp your phone.
2.  At this point, wireless charging will automatically begin. The GREEN LED charging light will be on.
3.  To remove your phone, fap the touch sensor on the back of the device fo open the arms

NOTE: This device has numerous safety features including overheat protection. In the eventofoverheating,it will shut off automatically. Unplug the device and let it cool down. Then, re-connect the device to resume charging.

WARNING

• Do not use this device for anything other than its intended purpose.
• Keep away from heat sources and direct sunlight.
• Operational temperature range: 32°F to 95°F.
• Do not let this device come in contact with water.
• If you have an electrical implant such as a pacemaker, consult yOur physician before using this product.
• Do not place a magnetic stripe card (credit card, ATM card, ID, etc.) near this product.
• Do not alter or attempt to repair this device. There are no user-serviceable parts.
• Use only the cable that came with this device.
• Keep out of reach of children at all times.

Any changes or modifications not expressly approved by the party responsible for compliance could void the User’s authority fo operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>