ANIMAL FACTORY AMPLIFICATION MAN-EM2 Pit Viper Eurorack Module User Manual
- June 5, 2024
- ANIMAL FACTORY AMPLIFICATION
Table of Contents
[ ](https://manuals.plus/wp-content/uploads/2022/04/ANIMALS-
LOGO.jpg)ANIMAL FACTORY AMPLIFICATION MAN-EM2 Pit Viper Eurorack Module
UPPER KNOBS
- LPF: The knob controls the amount of the filtered low-pass signal post drive.
- BPF: The knob controls the amount of the filtered band-pass signal post drive.
- HPF: The knob controls the amount of the filtered high-pass signal post drive.
- GAIN: Controls the amount the clipping circuit is engaged.
- VOLUME: Controls the overall volume of the distortion circuit.
- BLEND: Controls the balance between the dry and wet signal on the mix out.
LOWER KNOB
[
](https://manuals.plus
/wp-content/uploads/2022/04/NIMAL-FACTORY-AMPLIFICATION-MAN-EM2-Pit-Viper-
Eurorack-Module-1.jpg) LOWER KNOBS
- DYNAMICS CV: The attenuator controls the amount of CV signal that affects the dynamics of the circuit.
- FREQUENCY CV: Controls the amount of CV modulating the frequency. If no input is connected to FREQUENCY IN, this knob can be used to sweep the frequency.
- Q CV: Controls the amount of CV that modulates the Q amount for each filter band. The knob is normalized to control the Q amount if nothing is connected to Q IN.
- FM CV: Controls the amount of CV signal that affects the self-FM circuit. The knob is normalized to control the amount of FM if nothing is connected to FM IN.
SWITCHES
- SOFT SWITCH: The middle position applies no clipping, the top and bottom positions give two different flavors of “soft” clipping. Soft doesn’t mean nice and fluffy though.
- HARD SWITCH: The middle position applies no clipping, the top and bottom positions give two different flavors of “hard” clipping (a bit like limiting).
- MIDS SWITCH: Sets the amount of bass cut prior to the drive circuit.
AUDIO I/O
- INPUT: Input connector that takes in signal to be processed.
- DRY OUT: Sends out the unprocessed signal as is.
- WET OUT: The output of the distorted circuit pre-filter.
- MIX OUT: The output of the distorted signal with the filtered output.
CV I/O
- DYNAMICS IN: CV signal applied to the input controls the dynamics of the distortion circuit. IMPORTANT: This effect is best heard if GAIN is turned all the way down, and becomes less useful at higher settings.
- FREQUENCY IN: The CV signal applied to the input controls the cutoff point of each filter band.
- QIN: CV signal applied to the input controls the Q amount of each filter band.
- FM IN: CV signal to the input controls the bias applied to the FM circuitry of the band-pass filter.
SIGNAL FLOW
ENVIRONMENT
- Do not dispose of any part of this module in household waste.
- Electronics must be disposed of safely according to the electronics disposal norms in your country.
- This module was constructed using lead-free solder and observes compliance with the RoHS directive.
- All parts of our packaging are designed to use minimal or no plastic.
- Use the box and the velvet bag to keep other things safe.
TECHNICAL SPECIFICATIONS
- Power Draw: + 12V: 44mA – 12V: 43mA
- Size: 12HP Skiff friendly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>