ECOFLOW 2022083104 Rigid Solar Panel Mounting Feet User Manual
- June 3, 2024
- ECOFLOW
Table of Contents
ECOFLOW 2022083104 Rigid Solar Panel Mounting Feet
Disclaimer
Please read this User Manual and ensure you understand it fully before using the product. Please keep this User Manual properly for future reference. Any incorrect usage may result in severe injury to the user or others, damage to the product, or loss of property. By using this product, the user will be deemed as having understood, recognized, and accepted all the terms and contents of the User Manual, and will be responsible for any incorrect usage and all consequences arising therefrom. EcoFlow hereby disclaims any liability for any losses due to the user’s failure to use the product in accordance with the User Manual.
In compliance with laws and regulations, EcoFlow shall have the final right to interpret this document and all related documents for this product. Any update, revision, or termination of the contents thereof, if necessary, shall be made without prior notice, and users may visit the official website of EcoFlow for the latest information on the product.
Safety Instructions
Installation Position
This system is not possess any compliance with residential structural codes and should not be used in place of residential photovoltaic power generation systems.
Please install the solar panel on a stable and firm flat surface to avoid loosening or falling.
Modules can be mounted on top of a fixed outdoor object, and the system designer and installer shall be responsible for the compliance of the design of their supporting structure.
When installing systems on a vehicle or vessel, please observe relevant local and national laws and regulations.
Place the solar panel on a soft material to avoid friction with the ground during installation.
Check the connections of parts every three months to ensure that they are intact.
Operation Requirements
Do not use third-party accessories, which may cause system instability and the resulting risk is not covered by the warranty.
This product is suitable for EcoFlow rigid solar panel series, the models are as follows: 100W rigid solar panel (EF-SG-M100), 400W rigid solar panel (EF- SG-M400-04), it is not recommended to carry other solar panels for use.
This solar system is to be installed by a qualified solar installation company.
Packing List
- Z-shaped bracket
- Hex Self-Drilling Screw
- Hex Bolt (with Nut)
- M6 Large Washer
- M6 Flat Washer
- M6 Spring Washer
Recommended Tools
A 100W solar panel needs 1 set of support brackets, and a 400W
solar panel needs 2 sets of support brackets.
Be sure to wear protective gloves and safety goggles during installation to avoid being scratched.
The tools required for installation are not included in the list, please purchase them yourself.
Installation Steps for 100 W Rigid Solar Panel
- Apply the structural adhesive to the corresponding area (the surface contacting with the frame) of the z-shaped bracket.
- Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, and make sure that the mounting feet are evenly and symmetrically distributed.
- Apply structural adhesive to the round mounting holes of the Z-shaped bracket and then secure the module to the installation position with hex self-drilling screws.
Installation Steps for 400 W Rigid Solar Panel
- Apply the structural adhesive to the corresponding area (the surface contacting with the frame) of the z-shaped bracket.
- Fix the Z-shaped bracket on the solar panel mounting hole with hex bolts, and make sure that the mounting feet are evenly and symmetrically distributed.
- Apply structural adhesive to the round mounting holes of the Z-shaped bracket and then secure the module to the installation position with hex self-drilling screws.