national2way CWPTT-KEYS Wireless PTT Car Keys User Manual
- June 5, 2024
- national2way
Table of Contents
CWPTT-KEYS Wireless PTT Car Keys
User Manual
Model: CWPTT-KEYS
Transmitter: DC 3V, 225mAh battery inside
Receiver: DC 5V, 20mA power supply from the radio
** Before initial use, please pull the battery plastic safety separator from
the PTT.
(To open the key fob back cover, refer to “Battery Replacement” section.)
CHOICE Wireless Capable PTTs
Instructions:
- Power OFF the radio.
- Plug C+WPTT/C+WWPTT to the radio and then power ON the radio.
- Simultaneously press and hold the PTT button on CWPTT-KEYS and the Blue button on the rear side of C+WPTT/C+WWPTT for approx. 3 seconds to enter pairing mode.
- After successful pairing, the radio will be in TX mode, release both buttons.
- Once successfully paired, press PTT on CWPTT-KEYS once to exit pairing mode.
- Repeat the above steps to pair additional wireless PTT units with C+WPTT/C+WWPTT.
Battery Replacement:
- Remove the metal key blade from the key fob.
- Remove back cover.
- Remove the old battery.
- Replace with a new 2032 battery.
- Snapback cover of key fob in place.
ATTENTION
This device complies with part 15 of the FCC Rules and ISED Canada license-
exempt RSS standard(s). Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. The device can be used in portable exposure
conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>