wave SUPS B07Q61TZG8 11-3 Inch Inflatable Paddle Boards User Manual

wave SUPS B07Q61TZG8 11-3 Inch, Inflatable Paddle Boards

Instruction

WARNING: PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

1. IMPORTANT WARNING/DISPOSITIONS IMPORTANTES
   Warning: A Personal Flotation Device (PFD) is required for each user!Warning: Do not drive or jump! Warning: Keep away from fire! Warning: Do not leave product exposed under sunlight directly because it will shorten the using life of the product!Warning: Beware of offshore winds and currents. Do not use in high wind, open water!

2. INSTALLATION AND INFLATION/INSTALLATION ET GONFLAGE

3. DEFLATING AND STORAGE
   Clean your SUP after a trip to prevent damage from sand, salt water or sun exposure

4. ATTACH SEAT AS SHOWN BELOW INSTRUCTION OF VALVE
   If the valve is broken or leaky, following the next steps to replace the valve.

5. The Repair Kit includes glue and a PVC sheet. The Repair Kit can be used only if the leakage is 10 mm below.

6. LAY PADDLE BOARD AND SEAT FLAT

7. ATTACH TO CLIPS ON THE PADDLE BOARD

8. READY TO USE

WARRANTY

Product Warranty
Wave products have been inspected with no evident defects prior to leaving the factory. Wave warrants this product against defects in material and workmanship for a period of time, 1 year for the pump and paddle, 6 months for the liner, unless local law has special requirement. Warranty for this product begins on the date of dispatch and wave requires presentation of the original proof of purchase to confirm the date. During the warranty period, Wave will either repair or replace, at its discretion, any defective products. Replacement products or repaired parts will be warranted for the unexpired portion of the original warranty.

Shipping Cost Policy
The return of defect parts to the authorized service centre is at the cost of the owner On warranty period, the return is at the cost of service center.

Warranty Policy
This limited warranty does not apply to any defective parts resulting from negligence, accident, misuse, or other reason beyond Wave’s control, included but not limited to: normal wear and tear, negligence or failure to follow the product instructions, improper or inadequate maintenance connection to improper power supply; chemical water damage, loss of pool water, unauthorized product modification or repair; use for commercial purpose; fire, lightening, flood or other external causes. This warranty is valid only in the country of purchase in such countries where Wave sells and services the same model with identical technical specification country of purchase is limited to the terms and conditions Copyfish cOuntry of service. Where the cost of repairs or reptaceme will advise the owners and the cost shall be charged to the This warranty only applies to the original purchaser and te All repairs of which warranty claims are made must be preThis warranty only applies to the original purchaser and terminates upon any transfer of ownership. All repairs of which warranty claims are made must be pre-authorized by a Wave service centre. All the authorized selling dealer is responsible for all in-field service work carried out on your Wave product. Wave will not be liable for results of cost of workmanship from unauthorized service person.

Warranty Registration
To validate your warranty, please register your product on our website Wave:www.WAVESUPS.cOM It is essential that all informations including customer name, date of purchase, serial number, SUP model are provided. Without this information the warranty will be invalid.

• Wave Direct Limited
• 9-10 Charlotte Square
• Tyne and Wear, NE1 4XF, United Kingdom
• www.WAVESUPS.COM

REPAIR INSTRUCTION

1. Wipe from hull to hole with soap and water to find holes in the SUP. The soap will bubble over the hole.
2. Clean the area around the hole with water or alcohol.
3. Use a pencil to sketch out outline of the patch.
4. Cut a patch of a suitable size.
5.  Apply glue ebenly to the damaged area and then press and hold the patch to the damaged area.
6. Leave the SUP for at least 24hours or more before inflating it.

PACKING AWAY

Before deflating the SUP, ensure that you have removed the fin-guard and detached the fin to prevent the possibility of punctures. Wipe away any excess sand/dirt and make sure it is as dry as possible to prevent the possibility of dampness or mold. In the situation that your SUP is severely soiled, please apply mild soap and warm water, but avoid the use of corrosive chemicals.

Once you are happy with the condition of your SUP, twist the valve cap to remove and press the pushpin into deflate’ mode corresponding to the diagram next to the valve. Do not face directly over the valve as the pressure could cause some discomfort. The majority of the air will expel from the deflation pressure, but in order to get your board fully flat for optimal transportability you will need to do the following:

1. Sit on the end of the SUP opposite the valve and work your way towards the valve in a crawl-ike formation.
2. Once you are satisfied that all air has been expelled, roll your SUP from the opposing end to the valve in the way you would a sleeping bag.
3. Once you have reached the valve with the rear end of your SUP, push the pushpin to lock it and reattach the valve cap.
4. Use your SUP backpack as a guideline for the ideal size of your flattened UP- it needs to be small enough for the bag to accommodate both the SUP body and accompanying accessories.
   Please pack and store the SUP in the backpack provided in a cool dry place and away from direct sunlight to prevent the possibility of sun- bleaching/overheating of the PVC.

SAFETY AND CARE

• Ensure that the coiled ankle leash is attached at all times when aboard the SUP- upon exiting the water, ensure that your leash is not dangling to avoid it getting caught on rocks/causing potential accidents

• Weather depending, we recommend wearing a wetsuit and buoyancy aid at all times. Though our

• SUPs are in relatively bright colours, it is advisable to purchase a bright buoyancy aid to make yourself visible to any onlookers

• Utlise your cargo straps for emergency items such as water, mobile phone, food, whistle, torch (1CE) etc. The cargo nets’ expandable nature has the capacity to store both dry bags and cool bags with ease.

• Extreme weather conditions can be conducive to over/under-inflation- ensure that you use the PSI gauge mounted on the Wave pump to monitor your pressure periodically

• Board maintenance is necessary for ensuring the longevity of your board – avoid packing away damp and avoid any use of harsh chemicals

• Arepair kit including a PVC patch, adhesive, and valve wrench is provided – you may need to utilize
  these in case of damage. We recommend carrying your repair kit in the cargo luggage in case ofpotential air leaks. When tightening your SUP valve, first ensure the board is fully deflated, turning the valve clockwise until you can push no further and are confident that it is secured.

• In the event that any water was to enter the body of your SUP-remove the valve via the wrench provided and ensure your board is fully drained to prevent the possiblity of structural damage.

TROUBLESHOOTING

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>