ELECTRONIC FUEL INJECTION DF15902 DEFI Sports Digital Dashboard Display User Guide
- June 5, 2024
- ELECTRONIC FUEL INJECTION
Table of Contents
ELECTRONIC FUEL INJECTION DF15902 DEFI Sports Digital Dashboard Display User Guide
Quickstart Guide
Main Connector Plug
➢ Red Wire – 12V Constant/Battery
➢ Black Wire – Ground
➢ Yellow Wire – 12V Ignition
➢ Blue – 12V+ Door/Dome Light Trigger
➢ MS Tuning Cable into USB Port
➢ GPS Antenna
o Optional, used as 2nd trigger to start dash
***CAUTION: Make sure to install a Jumper Wire (With Factory Resistor or Fuse) between the vehicle’s alternator excite/sensing wire to the vehicles ignition wire when removing the instrument cluster or your alternator may not charge
Software Setup & Configuration
-
Wireless Connection – Click on Wireless Symbol (Bottom-Right) & complete network/password
-
TunerStudio Setup
➢ Activate Registration – Go to Help -> Enter Registration
➢ Disable “Check for Updates” – Go to Help and uncheck the “Automatic Update Check” box
➢ Preferences Setup – Go to Options -> Preferences and check both:
• Load Last Project on startup
• Make Dashboards Full Screen
➢ Data Rate Setup – Go to Communications -> Data Rate
• Set to “Max Reads Per Second”
➢ Close TunerStudio to save all settings to your Project -
TunerStudio Project Setup
➢ Update Communication Settings of Project File (Tuning Computer/Laptop)
• Open TunerStudio with your current tune on your tuning computer/laptop
• Go to Communication -> Settings and change Connection Typ e to RS232 Serial Interface
• Close TunerStudio & Copy Project from TunerStudioProjects folder to Thumb Drive
➢ Upload/Transfer Project File to Dash
• Close TunerStudio
• Plug-in Thumb Drive into an open USB Port on the Dash
• Copy Project File and Paste it to the TunerStudio Project folder
• Remove USB Drive (Important)
➢ Connection Settings
• Open TunerStudio
• Plug in your MS ECU Tuning Cable into Computer USB Port
• Go to Communication -> Settings click Detect and select USB option
➢ Gauge Lag Factor
• Go to Basic/Load Settings -> General Settings
• Under General Sensor Settings, increase the default 50 to 95 to speed up gauge refresh rate
➢ Close TunerStudio to save all settings to your Project
Disclaimer
Digital Dash EFI LLC makes no affiliations, representations, endorsements, sponsorships, or associations with the Raspberry Pi Foundation or EFI Analytics.
Digital Dash EFI LLC makes no representations or warranties of any type with respect to the contents in this manual. Digital Dash EFI LLC disclaims any implied warranties or fitness for any particular purpose. Digital Dash EFI LLC is not liable for any errors contained within or for incidental or consequential damages in connection with the supply, performance or use of the hardware and software or this manual.
Digital Dash EFI LLC reserves the right to revise this installation and user manual at any time, without obligation to notify any person of revisions. As defined by the Magnuson-Moss warranty Act, do not install any products or services unless you have the technical ability to properly set-up the entire vehicle to compensate for the installation of those products or services. The necessary work and expertise needed to install different products varies. Instructions, where provided, are given to assist in the installation only; they are not a substitute for mechanical experience in setting up vehicles. Digital Dash EFI LLC is not responsible for any personal or property damages caused by the installation of this product.
Warranty
Digital Dash EFI LLC makes every effort to ensure our products and services are of the highest quality and standards. This warranty applies to the ORIGINAL PURCHASER of this product and covers only those products exposed to normal use or service. Digital Dash EFI LLC warrants all merchandise manufactured by Digital Dash EFI LLC against defects in workmanship or material for a period of six (6) months after the date of purchase. This warranty does not apply to any product that has been damaged through alteration, improper installation, mishandling, misuse, neglect, or accident. Any part or product found to be defective after examination by Digital Dash EFI LLC will be repaired or replaced. Digital Dash EFI LLC assumes no responsibility for loss of time, diagnosis, removal and/or installation labor, loss of vehicle use, inconvenience or any other consequential expenses.
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty.
If you have any questions regarding warranty, please contact support at Digital Dash EFI LLC at support@dd-efi.com.
WARNING : California’s Proposition 65 requires that a clear and visible warning be provided to consumers in California that have the potential to expose them to various substances which may cause cancer, birth defects or other reproductive harm. Many of the products of Digital Dash EFI LLC utilizes manufactured products from Aluminum, Plastics, and other standard materials. These products can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>