streetwize SWGH3 Phone Holder User Manual
- June 5, 2024
- streetwize
Table of Contents
streetwize SWGH3 Phone Holder User Manual
Phone Holder
Never position the phone holder in a place that obscures the view of the
driver.
Intention for Use
This product is intended for ONLY holding smartphones only between the width of 49mm to 82mm. This gadget holder can be mounted in three different ways: vent clip – mount, dashboard adhesive mount & windscreen suction mount.
To get the best use of this product, we advise that you read all information in this document.
Product Elements
- Streetwize Universal Car Smartphone Holder (with attached suction mount)
- Adhesive pad for dashboard mount
- Vent-clip mount
Mounting the gadget holder
As mentioned, this product can be mounted in three different ways. Please follow the instructions for your preferred mounting option.
Windscreen Suction Mount
The windscreen suction mount option already comes attached out-of-the-box. To
use this option, simply unfold the gadget holder as shown in (Fig 1).
Mount the suction cup to your windscreen. Ensure the gadget holder is
unfolding towards you and not facing downwards towards the windscreen. Secure
the suction mount in place by turning the knob behind the suction cup
clockwise (Fig 2).
Then place your phone into the adjustable grip (Fig 3). The support arms
are spring loaded, simply pull apart to the required width for the phone,
adjust the angle to your requirements. With the suction mount, you can rotate
the device to view the device either horizontally or vertically.
To remove the suction mount from your windscreen, simply turn the knob anti- clockwise and pull one of the tabs on the suction cup.
Dashboard Adhesive Mount
To mount the gadget holder to your dashboard, get the supplied adhesive pad
(Fig 4) , peel off the red adhesive film and then fix it to your
dashboard. For added security screw into place via the three screw holes
(screws NOT included).
Use the suction mount to secure the gadget holder onto the dashboard pad.
Secure the suction mount in place by turning the knob behind the suction cup
clockwise (Fig 5- A)
Then place your phone into the adjustable grip. Adjust the angle to your requirements. With the suction mount, you can rotate the device to view the device either horizontally or vertically.
Vent-Mount Clip:
Please note, the phone holder will not rotate when using the vent-clip.
You will need to remove the suction cup mount from the phone holder. Hold the
device as per (Fig 6) and position your thumbs behind the adjustable arm
of the holder. push your thumbs forward until you hear a click, the suction
cup can now be removed.
Assemble the vent clip by positioning the vent grips (3) on the front cover as
shown in (Fig 7A). Simply place the attachment end of the vent clip
through the hole in the middle and
slide either left or right (Fig 7B).
Then attach the vent clip to the gadget holder (Fig 8).
Using the vent-mount clip, place the gadget holder on to your vehicle’s vent.
Ensure the vent clip is secured around the vent bars and the hinged bottom
support should be secured
into one of the vent bars at the bottom as shown in (Fig 9). Mount your
phone horizontally.
Streetwise: Ashburton Road West, Trafford Park, Manchester M17 1RY www.streetwizeaccessories.com
For product support:
E: [email protected]
T: +44 (0)161 447 8597
For trade enquiries:
E: [email protected]
T: +44 (0)161 447 8580
EU Registered address: The Ace Supply Co (Europe) Ltd , 25 Herbert Place, Dublin 2, D02 A098 Republic of Ireland.