HONBIKE F1 Chainfree Foldable and Shaft Drive Electric Bike User Guide
- June 5, 2024
- HONBIKE
Table of Contents
HONBIKE F1 Chain free Foldable and Shaft Drive Electric Bike
This Quick Start Guide is not a replacement for the Owner‘s Manual. The Complete Owner’s Manual contains other important information about your bike. For more information, please visit our web page or scan the QR code.
Assembly Guide
- Unfold the frame
- Mount the rear wheel
- Mount the rear fender
- Lifting the stem
- Install folding pedal
- Assemble the saddle kit
- Install the battery
Operation Guide
Charging the battery
Gently open the rubber cover and insert the charger plug into the charging port to charge the battery. Put the rubber cover on after the battery is fully charged. When the battery is fully charged, a green light on the charger indicates the charge is complete. A complete charge will take about 3.5-4 hours. Close the charge port lid to seal it from water and debris.
How to use the display
- Battery power
- Pedal-assist level
- Power button
- Plus button/ Light button
- Minus button/ Walk mode
- Power on/off Press and hold the Power button until the display is on/off
- Power assist Short press Plus button to increase the power assist level
- Turn on/off the light Short press Minus button to decrease the power assist level Press and hold the Plus button until the lights are on/off
Pedal-assist level
- Level 0 No motor assistance
- Level 1 & 2 Eco mode, low motor power assistance
- Level 3 & 4 Normal mode, medium motor power assistance
- Level 5 Sport mode, high motor power assistance
Before the first ride
-
Hinge and folding stand
- Check if the stem hinge and frame hinge are fixed, and if the frame is unfolded correctly in place before riding.
- Check whether the folding stand can be lifted and lowered normally. Make sure you have lifted the folding stand before riding.
-
Check if the bolts are tightened before riding.
-
Electrical system
- Make sure that you are familiar with the functions of all buttons and the meanings of the display information by referring to the content in the relevant sections of the electrical system.
- Before you set off for the first time, check whether the battery is fully charged, properly mounted and that it is locked.
- Check if the front light and rear light can be turned on normally and if the front and back reflectors are not damaged.
- Check if the display works normally.
-
Transmission system
- Push the bicycle forward and backward, check whether the front and rear wheels can rotate smoothly and whether there is any noise from the drive shaft to ensure that there is no stalling or unsteadiness during riding.
-
Tires
- Check tire pressure. Press the tires with your thumbs, which shall be solid and firm. If the tire pressure is insufficient, inflate to an air pressure of at least 3.4 – 3.6 bar (50 Psi), but over-inflation should be avoided.
-
Saddle
- Adjust the saddle to a proper height. Check that you can reach the floor with the tip of your toes when sitting on the saddle.
- Check if the seat post is locked tightly before riding to ensure that the saddle and seat tube are securely fastened.
-
Brake
-
US/EU: Left brake controls the front brake; Right brake controls the rear brake;
UK/CN/JP: Left brake controls the rear brake; Right brake controls the front brake; Try to use the rear brake first when braking. -
Stand next to the bicycle, pull the left and right brake levers at the same time and push the bicycle forward, the brake discs should be able to prevent the wheels from moving.
-
You need to try braking on a flat, non-slip surface to make sure you can get used to the braking effect of the HF01 before riding it in traffic on a public road.
-
-
Pedals
- Check whether the pedals are tightened onto the cranks and whether they can be folded and unfolded normally. Make sure that the pedals are unfolded before riding.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>