Okura U AP-BTM-1200 Wireless Music Stream Audio Receiver Instruction Manual
- June 5, 2024
- Okura U
Table of Contents
Okura U AP-BTM-1200 Wireless Music Stream Audio Receiver
OVERVIEW
Wiring Options:
- Red —- (+12V) Power
- Black (-12V) Ground
- Blue/White Strip- Remote Turn on (0utput to Amp)
- RCA – (3. 5mm) Audio output (Amp)
Unit installation
- Connect Red (+12/) wire to a constant power (battery)
- Connect Black (-12/) wire to chassis ground
- Connect the Blue/White Strip wire (remote out) to the amplifier
- Connect RCA output to the amplifier
Pairing your device (required for operation):
- Ensure your streaming device has wireless music stream enabled and that the power is turned on the AP-BTM-1200. (The blue LED on the AP-BTM-1200 will blink to indicate it is in pairing mode.)
- Within your streaming device’s wireless music stream setup menu, select “AP-BTM-1200” from the list of pairable devices.
- When successfully connected, the blue LED on the AP-BTM-1200 will stop blinking and remain lit. A single beep will be heard through the connected audio system.
FCC
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measurees
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCCRules. Operation is subject to the
following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements in
portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>