KARCHER SC1 Handheld Steam Cleaner Instruction Manual

SC 1
SC 1 Premium
SC 1 EasyFix
SC 1 EasyFix Premium
SC 1 EasyFix Premium Plus

Register
your product
www.kaercher.com/welcome

| |
---|---|---

Warranty

The warranty conditions issued by our relevant sales company apply in all countries. We shall remedy possible malfunctions on your appliance within the warranty period free of cost, provided that a material or manufacturing defect is the cause. In a warranty case, please contact your dealer (with the purchase receipt) or the next authorised customer service site. (See overleaf for the address)

Safety devices

CAUTION
Missing or modified safety devices are provided for your own protection. Never modify or bypass safety devices.
Symbols on the device
(according to type of appliance)

****| Risk of burns, surface of appliance becomes hot during
operation
---|---
| Risk of scalding from steam
| Read operating instructions

Safety lock
The safety lock seals the steam boiler from the steam pressure present. If the pressure regulator is defective and overpressure occurs in the steam boiler, an pressure relief valve opens in the safety lock and steam leaks out through the lock. Prior to restarting the appliance, contact the responsible KÄRCHER Customer Service.

Description of the unit

The maximum amount of equipment is described in these operating instructions. Depending on the model used, there are differences in the scope of delivery (see packaging).
For the illustrations, refer to the graphics page. Illustration A

Initial Start-Up
During initial start-up, a small cloud of smoke may be emitted from the steam nozzle. The appliance requires a short run-in time. At the start, the steam output is very irregular and damp, single droplets of water may even leak out. The steam volume that leaks out increases constantly until the maximum quantity has been reached after approx. 1 minute.

Installation

Installing accessories

1. Push the open end of the accessory onto the steam nozzle or steam gun until the unlocking button of the steam nozzle or steam gun engages.
   Illustration F
   Illustration I
   Illustration J

2. Push the open end of the accessory onto the spotlight nozzle.
   Illustration K

3. Connect the connection pipes with the steam nozzle or steam gun. a Push the 1st extension tube onto the steam nozzle or steam gun until the unlocking button of the steam nozzle or steam gun engages. The connection pipe is connected. b Push the 2nd extension tube onto the 1st extension tube. The connection pipes are connected. Illustration N

4. Push the accessory and/or the floor nozzle onto the free end of the extension tube. Illustration O The accessory is connected.

Disconnecting accessories

1.  Push the child lock down.
   Illustration G
   The switch is locked.

2. Push the unlocking button and pull the parts apart.
   Illustration L
   Illustration M

Operation

Filling water
Note
Descaling the steam boiler is not required if commercially available distilled water is used.
Note
Warm water reduces the heating-up time.
Note
To do this use the measuring jug supplied. When filling the water, pay attention to the marking (max. 200 ml).

1. Unscrew the safety lock.
   Illustration B

2. Fill a maximum of 200 ml distilled water or tap water into the steam boiler.

3. Insert the safety lock.
   Illustration C

Switch on the appliance
WARNING
Risk of scalding
The appliance has a high water outlet if you incline more than 30° to the side.
Do not incline the appliance more than 30° (maximum angle) to the side.

1. Place the appliance on a firm subsurface.

2. Insert the mains plug into a socket.
   Illustration D
   The indicator light lights up green.
   After approx. 3 minutes, the appliance is ready for use.
   Illustration E

3. Push the child lock up.
   Illustration G
   The switch is unlocked.

4. Press the switch.
   Illustration H
   Steam leaks out.

Refilling water
If the steam volume is reduced during work or if no more steam volume comes out, the water will have to be refilled.
Note The safety lock cannot be opened as long as the steam boiler is still pressurized.
Note Warm water reduces the heating-up time.

1. Switch the appliance off, see Chapter Switch off the appliance. Illustration Q
2. Unscrew the safety lock
3. Drain the water completely out of the steam boiler. Illustration R
4. Fill a maximum of 200 ml distilled water or tap water into the steam boiler.
5. Insert the safety lock. 6. Insert the mains plug into a socket.
6. Push the child lock up. The switch is unlocked. The appliance is ready for use.

Switch off the appliance

1. Pull the mains plug out of the socket.
   Illustration Q

2. Press the switch until no more steam escapes.
   The steam boiler is depressurized.

3. Push the child lockdown.

Rinsing out the steam boiler
Rinse the appliance’s steam boiler after completing the work.

1. Switch the appliance off, see Chapter Switch off the appliance.
2. Allow the appliance to cool down.
3. Disconnect the accessory.
4. Fill the steam boiler with water and swing it around vigorously. Lime residue which has been deposited on the bottom of the steam boiler will be released as a result.
5. Drain the water completely out of the steam boiler. Illustration R

Keep the appliance safe

1. Disconnect the accessory.
2. Drain the water completely out of the steam boiler. Illustration R
3. Coil the mains connection cable around the water reservoir. Illustration S
4. Allow the accessory to dry.
5. Store the appliance in a dry location that is protected from frost.

ATTENTION
Material damage due to a stuck safety lock
If the safety lock is not removed after cleaning, there is a possibility that the lock could get stuck in the thread. After cleaning, unscrew the safety lock and store it, for example, with the other device accessories.

Important application instructions

Cleaning the floor areas
We recommend sweeping the floor or vacuum cleaning it before using the appliance. In this way the floor will be cleared of dirt and loose particles before the wet cleaning. Freshening up textiles
Prior to using the appliance, always check the compatibility of the textiles at a concealed point: Steam down the textile, allow it to dry and then check it for any change in colour or shape.
Cleaning coated or painted surfaces
ATTENTION
Damaged surfaces
Steam can loosen wax, furniture polish, plastic coatings or paint and edge band from edges. Do not direct the steam at glued laminated edges as the edge band may loosen. Do not use the appliance for cleaning unsealed wood or parquet floors. Do not use the appliance for cleaning painted or plastic coated surfaces such as kitchen or living room furniture, doors or parquet. 1. To clean these surfaces, steam a cloth briefly and use it to wipe over the surfaces.
Glass cleaner
ATTENTION
Glass breakages and damaged surfaces
Steam can damage sealed points of the window frame and, at low outside temperatures, lead to tension on the surface of window panes and hence to glass breakages.
Do not direct the steam at sealed points on the window frame.
At low outside temperatures, heat up the window panes by gently steaming the full surface of the glass.

• Clean the window area with a manual nozzle and cover. To remove the water, use a squeegee or wipe the surfaces dry.

How to use the Accessories
Steam nozzle/steam gun
The steam nozzle or steam gun can be used for the following application areas without accessories:

• For removing slight creases from the hanging clothing items: Steam the clothing item from a distance of 10-20 cm.
• For wiping damp dust: Steam a cloth briefly and use it to wipe over the furniture.

Spotlight nozzle
The spotlight nozzle is suitable for cleaning areas, joins, fittings, drains, sinks, WCs, blinds or radiators that are difficult to access. The closer the spotlight nozzle is to the soiled area, the greater the cleaning efficiency will be as the temperature and steam volume are at their highest at the nozzle opening. Larger lime deposits can be treated before steam cleaning with a suitable detergent. Allow the detergent to soak in for approx. 5 minutes and then steam it off.
1. Push the open end of the spotlight nozzle onto the steam nozzle or steam gun. Illustration F Illustration J

Round brush
The round brush is used for cleaning stubborn dirt. Stubborn dirt can be removed more easily by brushing.
ATTENTION
Damaged surfaces
The brush may scratch sensitive surfaces. It is not suitable for cleaning sensitive surfaces.
1. Install the round brush on the spotlight nozzle. Illustration K
Power nozzle
The power nozzle is used for cleaning stubborn dirt, blowing down corners, joins etc.
1. Install the power nozzle onto the spotlight nozzle according to  theround brush. Illustration K

Manual nozzle
The manual nozzle is used for cleaning small areas that can be washed down, shower cubicles and mirrors.

1. Push the manual nozzle onto the steam nozzle or the steam gun according to the spotlight nozzle. Illustration J
2. Pull the cover over the manual nozzle.

Floor nozzle
The floor nozzle is used for cleaning washable wall and floor coverings e.g. stone floors, tiles and PVC floors.
ATTENTION
Damage due to build-up of steam
Heat and moisture can lead to damage.
Check the heat resistance and steam effect on an inconspicuous area using a minimal volume of steam prior to use.
Note
Detergent residue or care emulsions on the surface to be cleaned can lead to streaks ring steam cleaning, which will disappear however once these have been used several times.  We recommend sweeping the floor or vacuum cleaning it before using the device. In this way, the floor will be cleared of dirt and loose particles before the wet cleaning commences. Work slowly on surfaces that are heavily soiled so that the steam has longer to take effect.

1. Connect the extension tubes with the steam gun.
   Illustration N

2. Push the floor nozzle onto the extension tube.
   Illustration O

3. Fasten the floor cleaning cloth to the floor nozzle.
   a Place the floor cleaning cloth with the hook and loop fastener strips pointing upwards on the floor.
   b Place the floor nozzle onto the floor cleaning cloth, applying slight pressure.
   Illustration P
   The floor cleaning cloth will stick to the floor nozzle of its own accord due to the hook and loop fastener.

Removing the floor cleaning cloth

1. Place one foot on the bottom corner of the floor cleaning cloth and lift the floor nozzle up.
   Illustration P
   Note Initially, the floor cleaning cloth’s hook and loop fastener strip is very strong and cannot be removed from the floor nozzle easily. After the floor cleaning cloth has been used several times and washed, it is easier to remove from the floor nozzle and it has reached the optimum adhesion.

Care and service
Descaling the steam boiler
Note
Descaling the steam boiler is not required if commercially available distilled water is used.
Note
Since the lime becomes caked on the appliance, we recommend descaling the appliance as specified in the table (BF=boiler fillings) based on the number of times the steam boiler is filled.

Note
Your water board or municipal utilities authority can provide information on hardness of tap water.
ATTENTION
Damaged surfaces
The descaler may corrode sensitive surfaces.
Fill and empty the appliance carefully.

1. Switching off the device, see chapter Switch off the appliance.

2. Allow the device to cool down.

3. Unscrew the safety lock.

4. Drain the water completely out of the steam boiler. Illustration R
   ATTENTION
   Appliance damage due to descaler
   An unsuitable descaler or incorrect dosing of the descaler may damage theappliance.
   Only use KÄRCHER descaler.  Use 1 dosing unit  of the descaler for 0.5 l water.

5. Apply descaler solution to the descaler according to the details.

6. Fill the descaler solution into the steam boiler. Do not seal the steam boiler.

7. Allow the descaler solution to take effect for approx. 8 hours.

8. Drain descaler solution completely out of the steam boiler.

9. Repeat the descaling process if necessary.

10. Rinse the steam boiler 2-3 times with cold water in order to drain all the descaler solution residue.

11. Drain the water completely out of the steam boiler. Illustration R

Care of accessories
(Accessories – depending on scope of delivery)
Note
The micro fibre cloths are not suitable for dryer.
Note
When washing the clothes, observe the instructions on the washing tag. Do not use any liquid softeners as this will affect the ability of the clothes to pick up dirt.
1. Wash the floor cleaning cloths and covers at a max. the temperature of 60 °C in the washing machine.

Troubleshooting guide

Malfunctions often have simple causes that you can remedy yourself using the following overview. When in doubt, or in the case of malfunctions not mentioned here, please contact your authorized Customer Service.

WARNING
Risk of electric shock and burns
Trying to eliminate faults while the appliance is connected to the mains or has not yet cooled down is always dangerous.
Remove the mains plug.
Allow the appliance to cool down.
Reduced steam quantity
The steam nozzle is blocked.

1. Disconnect the accessory from the steam nozzle.
2. Clean the nozzle insert.
3. Start up the appliance briefly.
4. Attach the accessory to the steam nozzle. The steam boiler is scaled.

• Descale the steam boiler.
  No steam
  No water in the steam boiler

• Refill water, see Chapter Refilling water.
  The switch cannot be pressed
  The switch is locked with the child lock.

• Push the child lock up.
  The switch is unlocked.
  High water egress
  The appliance is “spitting out” water

• Do not incline the appliance more than 30° (maximum angle)  to the side during cleaning.

• Do not exceed the maximum filling quantity of 200 ml.

Technical data

Electrical connection

Voltage| V| 220-240
Phase| ~| 1
Frequency| Hz| 50-60
Protection class| | IPX4
Protection category| | I
Performance data

Heating capacity| W| 1200
Maximum operating pressure| MPa| 0.3
Heating-up time| Minutes| 3
Continuous steaming| g/min| 35
Maximum steam blast| g/min| 80
Filling quantity

Steam boiler| ml| 250
Maximum filling quantity| ml| 200
Dimensions and weights

Weight (without accessories)| kg| 1.5
Length| mm| 321
Width| mm| 127
Height| mm| 186

Subject to technical modifications.

http://kaer.ch/er/?l=TwSoJtl9IUOwZyAe1rHDyw

THANK YOU! MERCI!
Register your product and benefit from many advantages.
www.kaercher.com/welcome
Rate your product and tell us your opinion.
www.kaercher.com/dealersearch

71364 Winnenden (Germany)
Tel.: +49 7195 14-0
Fax: +49 7195 14-2212

Documents / Resources

| KARCHER SC1 Handheld Steam Cleaner [pdf] Instruction Manual
SC 1, SC 1 Premium, SC 1 EasyFix, SC 1 EasyFix Premium, SC 1 EasyFix Premium Plus, SC1, Handheld Steam Cleaner, SC1 Handheld Steam Cleaner
---|---

References

• Cher - Official Site
• Cleaning equipment and pressure washers | Kärcher International
• Cleaning equipment and pressure washers | Kärcher International
• Dealer Search | Kärcher International
• Home and Garden Warranty Registration USA - Kärcher

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>