frisco 2 Betta Aquarium with Divider-Top Instructions
- June 9, 2024
- frisco
Table of Contents
2 Betta Aquarium with Divider-Top Instructions
Review and follow all safety instructions!
- Product has g lass components that could break into pieces with sharp edges.
- Anyone under the age of 18 should not install, maintain or handle this product
- Never place excessive weight on top of glass canopies, aluminum screens, or tanks, which could cause accidental damage or excessive wear.
- Do not tap, tilt or play with any portion of this product. Glass products require close supervision when used by or near children, but should be kept out of their reach.
- Never lift or attempt to lift the aquarium/terrarium from the top frame.
- Never lift or move the aquarium/terrarium unless it is completely empty.
- Never lift the aquarium/terrarium unless both hands and the glass are completely dry.
- Never place the tank above electrical equipment.
- Aquarium/terrarium should always be carded from underneath, supporting the bottom at all times.
- Metal algae scrapers or other abrasive substrates can scratch or damage the glass su rface.
- The entire bottom frame of the aquarium/terrarium must wine in contact with the surface on which it sits. Any gaps between thesupport surface and the frame can cause flexing and leakage. The frame is best placed on a smooth, flat surface large enough to support its weight when filed.
- If damaged or leaking, immediately move your fish to a different tank and discard the damaged tank
- for indoor household use only. Do not use or store where it wil be exposed to extreme temperatures (freezing).
- Do not use for anything other than intended use. Never use with flammable or hazardous substances. Do not use accessories a appliances that are not recommended or sold for use with this product. Drilling, cutting, or otherwise modifying this product will void all warranties. Discard immediately if there is any damage.
TERRARIUM INSTRUCTIONS
Sliding screen slides out towards the front of the terrarium. To lock sliding screen in place, secure plastic locking clip along the middle, bad edge of the screen and terrarium. Catch the short end of the plastic clip along inner top edge of the screen (just above the mesh screen) and push long end of the plastic clip down flush against side of top frame of terrarium.
GLASS CANOPY INSTRUCTIONS
This glass canopy includes a handy handle, hinge, customizable backstrip, and
diamond polished edges for safety.
Hove to attach the handle: Make sure the glass canopy is on a cushioned, flat
surface. Find the best placement of the handle for you (we recommend 10-1 112″
from the center front edge of the canopy’s front section). Once you pick the
perfect spot, remove the paper backing from the adhesive strip on the handle
and press it firmly into place. Leave it alone for at least eight hours before
using it, so adhesive can set.
Hove to attach the backstrip: You can easily customize the plastic
backsuip to accommodate pumps, airline tubing, heaters, and other tank gear.
Place the glass canopy on top of the aquarium (designed to fit Frisco 5.5
Gallon Regular Aquarium) so that the section with the handle is fadng the
front, and the backstrip is towards the back. With glass canopy in place,
determine your intended placement of tank gear along the back of the aquarium
and measure the amount of space needed. Mark out the desired space to be cut
on the backstdp, then camfully slide it off the glass. Cut the plastic in line
with the markings and then slide the backstrip back into position. You can
then place the canopy back on the aquarium.
BETTA AQUARIUM INSTRUCTIONS
Aquarium indudes a glass canopy and glass dividers. Glass has diamond polished
edges for safety.
Glass canopy:
Make sure the glass canopy is on a cushioned, flat surface. Find the best
placement of the handle for you (we recommend 1″-1 14″ from the center front
edge of the canopy’s front section). Once you pick the perfect spot, remove
the paper backing from the adhesive strip on the handle and press it firmly
into place. Leave it alone for at least eight hours before using it, so
adhesive can set.
Glass Dividers:
Your fish will be safe and easy to view with the included glass divider(s)
that can be slid into a one-piece, pre-slotted frame to separate up to 2-3
betta fish (depending on aquarium model). Dividers have diamond polished edges
for safety. To install the glass divider(s), remove the glass from packaging
and carefully slide it into place in the pre-slotted frame. You aquarium can
then be customized as desired. Bottom edges of dividers can be anchored with
substrate of your choke fora habitat that alows your fish to co-exist safely
in the same aquarium.
Questions or concerns? Get help from our experts 24/7 (th1-800-672-4399
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>