VIVOHOME X002YGR6R9 Upgrade Automatic Ice Cube Maker Machine with Visible Window Instruction Manual

VIVOHOME X002YGR6R9 Upgrade Automatic Ice Cube Maker Machine with Visible

Window

Accessories

Installation

Before connecting the power cord, please put the machine upright for 24 hours to allow the refrigerant to settle. Unpack all packaging materials : foam, bags, tape, etc.

• The machine should be placed on a stable level to support the ice machine’s weight of water or ice.
• This machine can be installed without any support and can be installed in any place that meets the conditions of use and power supply.
• Use this machine in a well-ventilated area with temperature between 50°F and 100°F. Do not install the machine in a place with the following factors, such as wind, rain, water mist or electromagnetic.
• lnstall the machine away from the following factors, such as wind, rain, watermist or the electromagnetic environment.
• Do not place it next to high-temperature sources such as ovens and grills.

Control Panel

Operation

1. Insert the appliance’s main plug into the main socket.
2. Open the front cover, take out the ice basket, and pour water into the water tank. Do NOT exceed the MAX line.
3. Put back the ice basket. Make sure the water level is below the bottom of the ice basket, and then close the front cover.
4. After plugging it in, the appliance will be in standby mode and the “ICE‐MAKING” Quickly press the “ ” button once. The appliance will default to the big ice cube mode and begin producing ice.
5. The green “ICE‐MAKING” indicator light will stabilize.
6. During the ice-making cycle, press and hold the “ ” button for 3 seconds to switch to the small ice cube mode. The “ICE‐MAKING” indicator light will turn yellow.
7. During the ice-making cycle, quickly press the “ ” button once.

Tips:
When the ice box is full, the ice full indicator on the display panel wil light up (red), and the machine will stop automatically. When the ice is removed, the machine will restart working.

Ice Storage Capacity

• When the ice basket is full, the machine will stop automatically and stand by.
• The ice maker can partially block heat and store ice temporarily, but cannot be used as a freezer.
• Please remove ice cubes as needed and add water to ensure machine works normally.

Sound During Machine Operation

The new ice maker may make unfamiliar sounds. Most sounds are normal, for example:

• Compressor emits beating or sharp sounds.
• Water splashes from the evaporator to the tank.
• The sound of air compressed by the condenser fan over the condenser.

Cleaning And Maintenance

• Do not use solvent-based cleaning agents, which may damage the machine or cause retention of harmful substances.
• Do not rinse the outside of the machine directly with water, but wipe with a wet cloth instead.
• Dry the inside and outside of the machine with a soft and clean cloth.
• Disinfection solution: water and vinegar, or citric acid (ratio: 10:1).
• Wipe the interior with a neutral cleaning agent, including the hand-touchable evaporator (icing column).
• Add ice-making water, run the ice maker and discard the ice cubes produced in the reinstall the drain plug to ensure that the plug is in place.
• Re-use clean, soft cloth to clean the remaining watermarks. Finish cleaning.
• Disinfection solution: water and vinegar, or citric acid (ratio: 10:1).
• Wipe the interior with a neutral cleaning agent, including the hand-touchable evaporator (icing column).
• Add ice-making water, run the ice maker and discard the ice cubes produced in thereinstall the drain plug to ensure that the plug is in place.
• Re-use clean, soft cloth to clean the remaining watermarks. Finish cleaning.

Strange smell:
lf the ice has a strange taste, or if the ice has a disgusting or mildew odor in the machine, refer to the steps above to clean the inside of the machine.

Storage

If the ice maker is not used fora long time, cut off the power supply and remove the remaining water from the drainage outlet. Dry the interior with a clean soft cloth (refer to maintenance and cleaning). This sign” “‘on the product or packaging indicates that the product cannot be treated as household waste. It should be delivered to specific recycling points for electronic and electrical products. Proper handling of this product can help prevent possible environmental problems and harm to human body.lf you need more details about recycling, please contact the office responsible for household waste disposal services or the manufacturer or the point of purchase.

Safety Tips And Warnings

1.  Do not plug and unplug the machine with wet hands.
2.  Do not attempt to repair or replace any part of the ice machine unless under manufacturer’s guide, otherwise inspections should be performed under the direction of a technician.
3.  Use the machine in a well-ventilated area with a temperature between 50°F and 100°F.
4.  Do not install or operate the machine in a sealed space, such as a closed room.
5.  Do not install the machine in a place with the following factors, such as wind, rain, water mist or electromagnetic.
6.  Do not place it next to high-temperature sources such as ovens and grills.
7.  The use of ice makers must comply with national and local standards.
8.  Do not squeeze or twist the power cord of the ice machine.
9. In order to make the machine work properly, please lay it flat during use.
10. Check if there is any water leakage after adding water to the ice machine.
11. Children or people with mental disorders are not allowed to operate the ice machine.
12. Although the machine has been tested and cleaned at the factory, due to long-term transportation and storage, please dump the ice cubes made in the first 4 cycles.
13. If the machine has not been used for a long time, please clean it thoroughly before use.Please follow the instructions provided to clean and disinfect. Do not leave any solution after cleaning.
14. This machine is suitable for households or similar purposes such as family gatherings, bars, coffee shops, KTVs, teahouse, etc. Do not use this machine beyond its intended use.
15. If the device is no longer operating, please contact the manufacturer, a service agent, or a similar qualified technician who can help you with its operation.
16. This machine can only be filled with drinking water.
17. If the power cord is damaged, it must be replaced by a manufacturer, service agent or similar qualified person to avoid danger.
18. This device may not be used by persons who have physical, sensory or mental abilities, or who lack experience and knowledge, including children, unless they are supervised or prompted by the person responsible for their safety.
19. At least 6 inches of space should be left between the ice machine and any walls or other objects to ensure free circulation of air.
20. Do not use mechanical equipment or other means to accelerate the defrosting process except the method recommended by the manufacturer.
21. Do not damage the ice machine refrigeration tube.
22. Except for the type recommended by the manufacturer, the appliance shall not be used in the ice storage room of the appliance.
23. DO NOT clean the ice machine with flammable liquids. Doing so may result in a fireor an explosion.
24. It is forbidden to store explosives such as gasoline, combustion-supporting sprays or other flammable gases or liquids in this appliance.
25. Under no circumstances should the ice machine be inclined more than 45 degrees.
26. When the machine is working, it is strictly forbidden to touch the evaporator by hand.

Troubleshooting

If the machine breaks down, please wait for the machine to stop automatically. You can solve the problem by using the method in the table below. But don’t disassemble, inspect or repair the machine without professional guidance. This machine has a self-checking function. lf an error occurs, the ice-full and add-water indicator will flicker alternately, and the ice maker will stop working.

The machine does not respond.

| Not powered.|

Check the power supply. Check the power cord connection.

Check the power cord for damage.

There is no power in the power jack.
The power cord is not plugged
Power cord is damaged.| Call an authorized technician to repair.

Add water indicator light on.

| Lack of water.| Please add water and restart the machine.
Poor induction of the water shortage sensor.|

restart the machine.

Ice full indicator light on.

| Ice basket is full.| Please take out the ice cubes from the ice basket.
Poor induction of ice full sensor.| Clean the induction probe.

Ice cubes stick together.

| Ice making environment temperature or water temperature is too low.| Replace the water.

The recommended water temperature is at 45°F-90°F.

Ice cubes smaller than usual size.

| Ice making environment temperature or water temperature is too high.| Replace the water.

The recommended water temperature is at 45°F-90°F.

The machine is working properly but does not make ice.

| Refrigeration pipe blockage.| Call an authorized technician to repair.
Refrigerant leak.| Call an authorized technician to repair.
Add water and ice

alternately.

|

Ice cubes are stuck in ice box.

|

restart the machine after removing the stuck ice cubes.

Technical parameter

NOTE

To continuously improve its products, VIVOHOME reserves the right to modify this For any questions during assembly, please watch the video in the product page for reference. Or contact our customer service with any questions, comments, or concerns. Thank you for using VIVOHOME products in your home!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>