SolarWrap Redefine Solar Street Light User Manual
- June 5, 2024
- SolarWrap
Table of Contents
USER MANUAL
Materials in Package
Remark:
-
All MC4 male connectors ( including master and sub-modules) are positive 18/36V+.
And all MC4 female connectors are negative 18/36V2 : -
The type of MC4 connectors on the two sides of the MASTER MODULE are exactly the same.
That is to say: you can use either of two sides to connect to a solar light head or another device in the same way as using a regular solar panel. -
MC4 adapters (30cm) must be used between two solar cylinders.
(VERY IMPORTANT) -
The MC4 connectors with
RED cables are to connect master-module and sub-module -
All the connections between the master module and sub-module should be connected to each other including the last module of system
-
VERY IMPORTANT :
DO NOT CONNECT the MC4 male and female connector of the LAST MASTER MODULE.
Just leave them there or cut the connectors off.
Connection of Vertical Solar Street Light
Required Tools
Use the screwdriver to adjust the screws to a proper position according to the diameter of the pole.| Buckle the modular brackets on the pole, and Lock the two parts as one unit, make sure the bracket is at horizontal height. (VERY IMPORTANT).| Connect the two parts of the bracket and make the junction area flat and without any tilt.
This step is very important. otherwise, the solar module will be Inclined
| Fasten the 6 pieces of screws with the driver, and make sure the pole is in
the exact middle of the brackets.
Make sure the brackets are mounted very tight and strong enough, it can hold
50KG.| Put the first master module on the brackets in the right position.|
With another person’s help, slide the submodule along the track of the master
module and hold it before it reaches the bottom about 20cm.| Connect the sub
and master module by 2 pairs of red cable MC4 connectors at the bottom and top
places.
Put down the submodule to the bracket and adjust its position properly to
match the bracket.| Take out the two MC4 cables from the master module
carefully, Hold it and do not let it fall into the modules.| Put second
brackets over the module in opposite direction to the bottom brackets. Install
it in the same way as installing the first brackets.| Adjust the position of
the bracket at the best position. Similarly, let the pole in the middle of the
hexagon bracket.
Fasten the 6 pieces screws with driver carefully.| Put the third bracket on
the top bracket, ano take out the two MC4 cables of the first module through
the third bracket.| Connect the 2pcs of MC4 adapter cable to the MC4
connectors of the first module.| Put the second master module on the bracket
in the same way as Step 6 shows.
Connect the second master module to the first module via the MC4 adapters
(30cm)| Make sure all the PLUG-in connections are very tight and strong, well
connected.| Install the sub-module of the second module in the same way as the
step.| installation completed
MC4 Adapter MUST BE ADOPTED between two up and down modules.
The quality you can trust
AURORAS INNOTECH (GUANGDONG) CO., LTD
www.auroraslighting.com
+86 0756 8530887 +86 0756 8500385
+86 180 2307 5361
[email protected]
2nd Building, 639# Huayu road, Zhuhai 519000, P.R.C
http://www.auroraslighting.com