ECOFLOW Delta 1300 Portable Power Station User Manual
- June 5, 2024
- ECOFLOW
Table of Contents
ECOFLOW Delta 1300 Portable Power Station
Specifications
Safety Instructions
- Do not use the product near a heat source, such as a fire source or a heating furnace.
- Avoid contact with any liquid. Do not immerse the product in water or get it wet. Do not use the product in rain or humid environments.
- Do not use the product in an environment with strong static electricity/magnetic fields.
- Do not disassemble the product in any way or pierce the product with sharp objects.
- Avoid using wires or other metal objects that may result in a short circuit.
- Do not use unofficial components or accessories. If you need to replace any components or accessories, please visit official EcoFlow channels to check relevant information.
- When using the product, please strictly follow the operating environment temperature specified in this user manual. If the temperature is too high, it may result in a fire or explosion; if the temperature is too low, the product performance may be severely reduced, or the product may cease to work.
- Do not stack any heavy objects on the product.
- Do not lock the fan forcibly during use or place the product in an unventilated or dusty area.
- Please avoid impact, falls, or severe vibrations when using the product. In case of a severe external impact, turn off the power supply immediately and stop using the product. Ensure the product is well fastened during transportation to avoid vibrations and impacts.
- If you accidentally drop the product into water during use, please place it in a safe open area, and stay away from it until it is completely dry. The dried product should not be used again, and should be properly disposed of according to Section 2.2 below. If the product catches fire, we recommend that you use the fire extinguishers in the following order: water or water mist, sand, fire blanket, dry powder, and finally a carbon dioxide fire extinguisher.
- Use a dry cloth to clean off dirt on the product ports.
- Rest the product on a flat surface to avoid damages caused by the product falling over. If the product is overturned and severely damaged, turn it off immediately, place the battery in an open area, keep it away from combustible matter and people, and dispose of it in accordance with local laws and regulations.
- Ensure that the product is kept out of reach of children and pets.
Disposal Guide
Safety Instructions
- If conditions permit, make sure that the battery is fully discharged before disposing it in a designated battery recycling bin. The product contains batteries with potentially dangerous chemicals, so it is strictly prohibited to dispose of it in ordinary trash cans. For more details, please follow the local laws and regulations on battery recycling and disposal.
- If the battery cannot be fully discharged due to a product failure, please do not dispose of the battery directly in the battery recycling box. In such case, you should contact a professional battery recycling company for further processing.
- Please dispose of over-discharged batteries that cannot be recharged.
Getting Started
LCD Screen
General Product Usage
Product On, Product Off, LCD Screen On
The product enters sleep mode after 5 minutes of idle operation; the LCD Screen will automatically turn off. When the product senses any load change or operations, the LCD Screen will automatically light up. To turn the LCD Screen on or off, please short press the Main Power Button. To power off the product, press and hold the Main Power Button. The default product standby time is 2 hours. With other Power Buttons turned off and no other load access for 2 hours, the product will automatically shut down
USB Output Port
With the Main Power Button turned on, short press the USB Power Button to use the USB Output Port. Short press the USB Power Button again to turn it off. With the USB Power Button on, the product will not automatically shut down. AC Output Port
With the Main Power Button turned on, short press the AC Power Button to use the AC Output ports. Short press the AC Power Button again to turn it off. The default standby time of the AC Output port is 12 hours. Without any load access for 12 hours, the AC Power Button will automatically turn off. Please turn off AC power button when not in use to save power consumption
AC Charging
EcoFlow’s X-Stream fast charge technology is specifically for AC charging,
offering 1200W/1000W of max input power. In case of unusual situations where
the AC input current remains higher than 10A, the X-Stream charging input port
will initiate a self-protection function, and the Overload Protection Switch
on the product will automatically pop up. After confirming that there is no
product failure, you can press the Overload Protection Switch to resume
charging.
Solar Charging
Users can connect solar panels in series as shown in the figure to recharge
the product. The product supports 10-65V DC input, 10A max current, and 400W
max charging power
Car Charging
Users can recharge the product through the Car Charging Input Port. It
supports 12V/24V car chargers and an 8A default charging current. Please
charge using the car charger after you’ve started the car to avoid failure to
start due to insufficient car battery. In addition, please make sure that Car
Charging Input Port and the Car Charging Cable are in good condition. EcoFlow
takes no responsibilities for any losses or damages caused by failures to
follow instructions.
Emergency Power Supply (EPS)
The product supports EPS. When you connect the grid power to the AC Input Port
of the product through an AC Charging cable, you can power electrical devices
through the AC Output Sockets (AC power will come from the grid and not the
power station in this situation). In case of a sudden blackout, the product
can automatically switch to the battery powered supply mode within 30ms. As a
basic UPS function, this function does not support 0ms switching. Please do
not connect the product to any device that requires 0ms UPS, such as data
servers and workstations. Please test and confirm the compatibility before
using the product. We recommend that you only charge one device at a time and
avoid using multiple ones at the same time to avoid overload protection.
EcoFlow takes no responsibilities for any device failures or data losses
caused by failures to follow instructions.
Troubleshooting
What’s In the Box
Storage & Maintenance
- Please use or store the product in an environment temperature between 68°F to 86°F, away from water, heat, and other metal objects.
- For long-term storage, please discharge the battery to 30% and recharge it to 60% every three months.
- For safety, please do not store the product in an environment temperature higher than 113°F or lower than 14°F for a long time.
- If the remaining battery is less than 1% after you finish using the product, please recharge it to 60% before storing. If the product is left idle for a long time with severely low battery, irreversible damages may be caused to the battery cell and the product service life will be shortened.
- If the product has been idle for too long and the battery is severely low, it will enter a deep sleep protection mode. In such case, please charge the product before using it again
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>