AlfredCamera AC101A Security Camera User Guide
- June 5, 2024
- AlfredCamera
Table of Contents
Quick Start Guide
AlfredCam
Open the box, and you will see…
Know more about AlfredCam
Let’s set up the device together
- Download the AlfredCamera app on the App Store/Google Play. Launch the app, then Sign In or Create a New Account.
- Power on the device and wait for the Status LED to slowly blink green.
- Tap Add a Camera and follow the app instructions to set up your device.
Have trouble installing your new product? Visit AlfredCamera Help Center for further assistance.
https://alfredcamera.zendesk.com/hc
https://alfredcamera.zendesk.com/hc/zh-tw
Mounting the camera
| 01. Place the alignment sticker where you would like to
place the camera.
---|---
02. Use an 8mm drill bit to drill two 25mm deep holes as indicated on the
alignment sticker.
| 03. Hammer in the plastic wall anchors to support the
screws.
| 05. Attach your camera to the screws by sliding down.
Or place the 3M sticker on the mounting stand
In case you have questions
What do I do when my device is not working properly?
First, reset and reinstall your device:
- Use a paper clip to press the Reset button next to the SD card slot
- Wait until the LED turns solid red Next, follow these steps during installation:
- Connect your router to the Internet and enable Wi-Fi
- Connect your mobile device to your router’s 2.4G Wi-Fi
- Ensure that your AlfredCam device is in range of the same Wi-Fi network
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: this device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>