REMINGTON R6000 Style Series Aqua Rotary Shaver User Manual
- June 5, 2024
- Remington
Table of Contents
REMINGTON R6000 Style Series Aqua Rotary Shaver
Thank
you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been supervised/instructed and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children unless they are older than 8 and supervised. Keep the appliance and cable out of reach of children under 8 years.
Suitable for use in a bath or shower. -
Do not use the product with a damaged cord.
-
The battery in this device is not replaceable.
-
Do not use the appliance if it is damaged or malfunctions.
-
Do not use attachments other than those we supply.
-
This appliance should never be left unattended when plugged into a power outlet, except when charging.
-
Keep the power plug and cord away from heated surfaces.
-
Do not plug or unplug the appliance with wet hands.
-
Do not twist or kink the cable, or wrap it round the appliance.
-
This appliance is not intended for commercial or salon use.
PARTS
-
On/off switch
-
Pivoting head and cutter assembly
-
Flexing heads
-
Hairpocket
-
Charging indicator lights
-
Detail trimmer
-
Trimmer release button
-
Power connector
Not shown -
USB charging cable
-
Cleaning brush
-
Stubble head guard
GETTING STARTED
CHARGING
- Ensure the product is switched off.
- Connect the product to the USB cable and then to the USB end of the cable to a powered USB port.
CHARGING INDICATOR LIGHTS
- Run time from fully charged is up to 60 mins.
- Charge time from empty is 90 mins.
- Note: To preserve the life of your batteries, let them run out every 6 months then fully charge.
QUICK CHARGE FEATURE
- Your shaver has a 5 minute quick charge feature that will provide enough charge for 1 shave (3 minutes).
INSTRUCTIONS FOR USE
SHAVING
- Switch the shaver on by pressing the on/off button.
- Stretch the skin with your free hand so the hairs stand upright.
- Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and make them vulnerable to breakage).
- Use short, circular strokes.
TRIMMING
- Push the trimmer button to release the detail trimmer.
- Hold the trimmer at a right angle to your skin.
- Place the trimmer at desired trim line for a quick, easy professional trim.
- To retract the trimmer, push down until it locks into position.
STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.
TIPS FOR BEST RESULTS
- Always hold the shaver at right angles to the skin so that all three heads are touching the skin with equal pressure.
- Use moderate to slow stroking movements. The use of short circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
- DO NOT press hard against the skin in order to avoid damage to the rotary heads.
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you
clean your appliance after each use.
Ensure the appliance is switched off and unplugged from the mains before
cleaning. 
- Open the shaver head by pressing the release button (Fig. A).
- Empty out any hair clippings.
- Pull the shaver head upwards to remove it from the body (Fig. B).
- Locate the centre arrow and slide the retainer in the opposite direction to release it. Once released, lift it out of the shaver head (Fig. C). Make a note of the correct orientation of the retainer to make refitting easier.
- Carefully brush away any hairs from the cutters.
- For a more thorough cleaning, lift out the three cutters (Fig. D).
- Wash the shaving head under running water (Fig. E). Allow to dry thoroughly.
- Carefully refit the three cutters.
- Refit the retainer. Locate the centre arrow and slide the retainer in the same direction as the arrow until it clicks into place (Fig. F).
- Once the shaver head is assembled, align the spring hinge with the slot at the back of the hair pocket and press into place (Fig. G). Snap the head assembly closed.
TRIMMER
Lubricate the teeth of the trimmer every six months with a drop of sewing
machine oil.
REMOVING THE RECHARGEABLE BATTERY
We strongly recommend that a professional removes the rechargeable battery. Parts of the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
The rechargeable battery must be removed from the appliance before it is
scrapped.
Disconnect the charging adapter before removing the battery.
- Run the shaver until the motor stops.
- Unplug the shaver.
- Carefully pry off the front housing.
- Unscrew the 6 screws on the inner housing.
- Carefully pry off the back housing.
- Lift the battery carrier and circuit board out of the shaver body then cut the tabs holding the batteries to the circuit board.
Used batteries must be removed from the appliance and disposed of at an
appropriate official recycling/collection point.
Do not attempt to operate the shaver once you have opened it.
RECYCLING
To avoid environmental and health problems due to hazardous substances,
appliances and rechargeable and non-rechargeable batteries marked with one of
these symbols must not be disposed of with unsorted municipal waste. Always
dispose of electrical and electronic products and, where applicable,
rechargeable and
non-rechargeable batteries, at an appropriate official recycling/collection
point.
Ref. No. R6000
Type No. R13A
20/INT/ R6000 T22-7001613-B Version 12 /20
Remington® is a Registered Trade Mark of Spectrum Brands,Inc., or one of its
subsidiaries
VARTA Consumer Batteries GmbH & Co. KGaA, Alfred-Krupp-Str. 9, 73479
Ellwangen, Germany remington-europe.com
© 2020 Spectrum Brands, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>