velleman HQLE10028 LED WATER LIGHT 7 COLOURS User Manual
- June 5, 2024
- Velleman
Table of Contents
HQLE10028
USER MANUAL
LED WATER LIGHT – 7 COLOURS
Introduction
To all residents of the European Union Important environmental
information about this product
This symbol on the device or the package indicates that disposal of the device
after its lifecycle could harm the environment. Do not dispose of the unit (or
batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling. This device should be returned to your distributor or
to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower™! Please read the manual thoroughly before
bringing this device into service. If the device was damaged in transit, do
not install or use it and contact your dealer.
WARNING
Please read the following safety instructions carefully before using this
product.
This device can be used by children aged 8 years and above, and persons with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning the
use of the device in a safe way to understand the hazards involved. Children
shall not play with the device. Cleaning and user maintenance shall not be
made by children without supervision. Always connect the device to a grounded
circuit to avoid the risk of electrocution. Always disconnect mains power when
the device is not in use or when servicing or maintenance activities are
performed. Handle the power cord by the plug only.
If the external flexible cable or cord of this device is damaged, it shall be
replaced by a special cord or cord exclusively available from the manufacturer
or his service agent. All cords and cables should be routed so that they will
not be walked on or pinched by items placed upon or against them. Pay
particular attention to the point where they exit the unit. Remove all
flammable materials close to the device before switching on. Do not install
the device on a flammable surface (linoleum, carpet, wood, paper, cardboard,
plastic, etc.). Protect this device from heat sources such as radiators, heat
registers, stoves, or other appliances (including amplifiers) that produce
heat.
Do not remove the cover under any conditions. There are no user-serviceable
parts inside. Never operate this device when its cover is removed. Do not
operate a visibly damaged device. Do not attempt to operate this device if the
power cord has been frayed or broken. Always mount this device in a safe and
stable manner. Mount this device in an area that will allow proper
ventilation. Allow about 15 cm between this device and a wall. This device
should only be serviced by qualified service personnel. Do not use the
luminaire with a cracked or broken protective shield. Disconnect immediately
from the mains. The protective shield is not replaceable.
Familiarise yourself with the functions of the device before actually using it. Keep this manual for future reference. Always make sure to connect the device to an alternating current matching the value stated on the device. Always install the device in a well-ventilated location. Keep this device away from dust and extreme temperatures. Make sure the ventilation openings are clear at all times. For sufficient air circulation, leave at least 2.5 cm in front of the openings. Never connect the device to a dimmer or rheostat. Never carry or move the device from the power cord or any other moving part. Always use the bracket. In the event of an operating problem, stop using the device immediately. Never try to repair the device. There are no user-serviceable parts inside the device. Refer to an authorized dealer for service and/or spare parts. This device is not designed for permanent operation: regular operation breaks will prolong its life.
Indoor use only. Keep this device away from rain, moisture, splashing and
dripping liquids. Never put objects filled with liquids on top of or close to
the device.
This device is not suitable for ordinary lighting in household room
illumination. Power supply polarisation.
Warranty
Refer to the Velleman® Service and Quality Warranty on the last pages of this
manual. All modifications of the device are forbidden for safety reasons.
Damage caused by user modifications to the device is not covered by the
warranty. Only use the device for its intended purpose. Using the device in an
unauthorized way will void the warranty. Damage caused by disregard of
certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical…)
arising from the possession, use or failure of this product. Keep this manual
for future reference.
Installation
4.1 General Guidelines
Have the device installed by a qualified person, respecting all applicable
norms. Install the device on an even, fire-resistant, scratch-resistant,
water-resistant, and non-slippery surface. The carrying construction must be
able to support 10 times the weight of the device for 1 hour without
deforming. Make sure there is no flammable material within a 1 m radius of the
device. Install the device in a location with few passers-by that is
inaccessible to unauthorized persons. Install the device in a location where
you can easily access the power cord. Install the device in a well-ventilated
area.
4.2 Overhead Installation
When hung, the device must always be secured with a secondary attachment e.g.
a safety cable.
Never stand directly below the device when it is being mounted, removed or
serviced. Have a qualified technician check the device once a year and once
before you bring it into service.
Overhead mounting requires extensive experience: calculating workload limits,
determining the installation material to be used… Have the material and the
device itself checked regularly. Do not attempt to install the device yourself
if you lack these qualifications as improper installation may result in
injuries. For truss mounting, use an appropriate clamp (not incl.) and fit an
M10 bolt through the center of the (folded) bracket.
4.3 Secondary Suspension
Hanger
Where a hanger is provided, the bearing parts of the hanger shall be capable
of supporting ten (10) times the weight of the luminaire without permanent
deformation and shall be manufactured from non-combustible materials such as
steel or its equivalent.
Accessories
The design of the luminaire shall be such that removable accessories, e.g.
color frames and barn doors, when properly inserted, cannot fall out of the
luminaire.
Secondary Suspension
A secondary suspension shall be provided for the luminaire, except where the
luminaire is arranged for floor mounting or if it is intended for handheld
use. The secondary suspension shall be designed and mounted in such a way that
in the event of a failure of the primary suspension, no part of the luminaire
can fall. The secondary suspension must withstand a 30 cm vertical drop for 30
times.
Overview
Refer to the illustrations on page 2 of this manual.
| 1 | mode control |
|---|---|
| 2 | function switch |
| 3 | microphone |
| 4 | IR receiver |
Operation
Connect the device to the mains using the included power adapter. Switch on the device and select the working mode.
| switch | description |
|---|---|
| 1 | on-off |
| 2 | auto mode |
| 3 | sound mode |
| mode | description |
| --- | --- |
strobe
- manual| red
green
blue
white
red + green
blue + green
white + blue
blue + red
white + green
red + green + white
white + green + blue
red + green + white
red + blue + white
red + green + blue + white
auto| auto mode
sound| music-controlled mode
sound| music-controlled mode with jumping colours
auto| auto mode with jumping colours
Remote Control
WARNING
Do not puncture batteries or throw them in the fire as they may explode. Do
not attempt to recharge non-rechargeable batteries (alkaline). Dispose of
batteries in accordance with local regulations. Keep batteries away from
children.
| button | description |
|---|---|
| ON/OFF | device on-off |
| W | white |
| RGBYCP | red, green, blue, yellow, cyan, purple |
| MOTOR STOP | rotation on-off |
| SPEED | speed control |
| AUTO | auto colour change |
| MUSIC | sound mode |
| FLASH | flash mode |
Cleaning and Maintenance
Before starting any cleaning or maintenance activities:
- Unplug the device’s power cord from the outlet.
- Let the device cool down.
Cleaning
Use normal glass cleaner and a soft cloth to wipe off the outside casing.
Always be sure to dry all parts completely before plugging the device back in.
Cleaning frequency depends on the environment in which the unit operates (i.e.
smoke, fog residue, dust, dew). Do not immerse the device in any liquid.
Maintenance
All screws should be tightened and free of corrosion. The housing, the lenses,
the mounting supports, and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified, or tampered with; e.g.
do not drill extra holes in mounting supports, do not change the location of
the connections… Mechanically moving parts must not show any signs of wear and
tear. The electric power supply cables must not show any damage. Have a
qualified technician maintain the device. There are no user-serviceable parts,
apart from the fuse and the lamp. Refer to an authorized dealer for service
and/or spare parts.
Technical Specifications
power supply ……………………………………………… 5 VDC, 1.2 A (adaptor incl.)
power consumption ……………………………………………………………………. 6 W
light source ………………………………………………………….. 4 x 3 W RGBW LED
control range ……………………………………………………………………….. < 10 m
dimensions ……………………………………………………………. 117 x 91 x 51 mm
weight …………………………………………………………………………………. 450 g
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulting from (incorrect) use of
this device. For more info concerning this product and the latest version of
this manual, please visit our website
www.velleman.eu. The information in this manual is
subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights
reserved. No part of this manual may be copied, reproduced, translated or
reduced to any electronic medium or otherwise without the prior written
consent of the copyright holder.
Velleman® Service and Quality Warranty
Since its foundation in 1972, Velleman® acquired extensive experience in the
electronics world and currently distributes its products in over 85 countries.
All our products fulfill strict quality requirements and legal stipulations in
the EU. In order to ensure the quality, our products regularly go through an
extra quality check, both by an internal quality department and by specialized
external organizations. If, all precautionary measures notwithstanding,
problems should occur, please make an appeal to our warranty (see guarantee
conditions).
General Warranty Conditions Concerning Consumer Products (for EU):
-
All consumer products are subject to a 24-month warranty on production flaws and defective material from the original date of purchase.
-
Velleman® can decide to replace an article with an equivalent article or to refund the retail value totally or partially when the complaint is valid and a free repair or replacement of the article is impossible, or if the expenses are out of proportion.
You will be delivered a replacing article or a refund at the value of 100% of the purchase price in case of a flaw occurred in the first year after the date of purchase and delivery, or a replacing article at 50% of the purchase price or a refund at the value of 50% of the retail value in case of a flaw occurred in the second year after the date of purchase and delivery. -
Not covered by warranty:
– all direct or indirect damage caused after delivery to the article (e.g. by oxidation, shocks, falls, dust, dirt, humidity…), and by the article, as well as its contents (e.g. data loss), compensation for loss of profits;
– consumable goods, parts or accessories that are subject to an aging process during normal use, such as batteries (rechargeable, non-rechargeable, built-in or replaceable), lamps, rubber parts, drive belts…(unlimited list);
– flaws resulting from fire, water damage, lightning, accident, natural disaster, etc.…;
– flaws caused deliberately, negligently or resulting from improper handling, negligent maintenance, abusive use or use contrary to the manufacturer’s instructions;
– damage caused by a commercial, professional or collective use of the article (the warranty validity will be reduced to six (6) months when the article is used professionally); – damage resulting from an inappropriate packing and shipping of the article;
– all damage caused by modification, repair, or alteration performed by a third party without written permission by Velleman®. -
Articles to be repaired must be delivered to your Velleman® dealer, solidly packed (preferably in the original packaging), and be completed with the original receipt of purchase and a clear flaw description.
-
Hint: In order to save on cost and time, please re-read the manual and check if the flaw is caused by obvious causes prior to presenting the article for repair. Note that returning a non-defective article can also involve handling costs.
-
Repairs occurring after warranty expiration are subject to shipping costs.
-
The above conditions are without prejudice to all commercial warranties. The above enumeration is subject to modification according to the article (see article’s manual).
Made in PRC
Imported by Velleman nv
Legen Heirweg 33, 9890 Gavere, Belgium
www.velleman.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>