Guangdong Shunde Sankey Electronic Technology 22040061 Remote Control User Manual
- June 5, 2024
- Guangdong Shunde Sankey Electronic Technology
Table of Contents
Remote control
user manual
Function Introduction
No. 22040061
- Led Indicator
- Speed Control
- Fan Off
- Fan Reverse/Forward Press this Key when the fan works
- Natural Wind
- Timer
- Turn On The Light
- Turn Off The Light
Pairing Method
You will hear the sound of “Beep” when the receiver is switched on. And then, please press the “ ” key immediately till you hear the song “Beep” sound. It means pairing successfully. Tips: The remote control has been paired before leaving the factory and it can be used directly after installation. Re-pairing is required when you need to add or replace a new remote.
Notices
- When the emitter is unable to remotely control the receiver, please check whether the emitter’s batteries are in good contact, whether they are fixed properly and whether they run out of use.
- When the emitter is unable to remotely control the receiver, please check whether there is other remote control products around the space and check whether the keys are pressed down, because the same nature of the remote control product may cause interference with each other resulting in a poor receiving effect. Taking away such articles will normalize the remote control function. (the infrared remote controller is not included).
- Please use this product under applied voltage. Too low voltage will lead to the failure of the remote controller to work (Please refer to the product label for the voltage range and related parameters).
- Please take out the batteries if you will not use this product for a long time.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.