REMINGTON R95 Dual Flex Rotary Shaver User Guide

REMINGTON R95 Dual Flex Rotary Shaver User Guide

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this shaver.

DANGER

To reduce the risk of electric shock:

• Do not reach for an appliance that has fallen into water. Unplug it immediately.
• Do not use while bathing or in the shower.
• Do not place or drop into water or other liquid.
• Do not place or store this appliance where it can fall or be pulled into a tub or sink.
• Except when charging, always unplug this appliance from the electrical  outlet immediately after using.
• Use only when the shaver is in dry condition.
• Detach the appliance from the power supply cord before cleaning.
• Do not submerge in water.

WARNING

To reduce the risk of burns, fire, electric shock, or injury to persons:

• An appliance should never be left unattended when it’s plugged in, except when charging a rechargeable appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
• Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
• Never operate this appliance if it has a damaged cord or plug or if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water.
• Keep the cord away from heated surfaces.
• Never drop or insert any object into any of the appliance’s openings.
• Household use only.
• Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
• Always attach the plug to the appliance, then to outlet. To disconnect, turn all controls to OFF, then remove plug from outlet.
• Always pull on cord plug to unplug from wall socket. Never pull on electric cord.
• Do not plug or unplug this appliance when your hands are wet.
• Do not use an extension cord or a voltage converter with this appliance.
• Do not wrap the cord around the appliance.
• Always store this appliance and cord in a moisture-free area. Do not store it in temperatures exceeding 140°F (60°C).
• Detach removable power cords from appliance for storage.
• Do not use this appliance with a damaged or broken head or cutters, as facial injury may occur.
• Shavers, including the trimmer, are for use on facial hair only. They should not be used for shaving the hair on your head or any other part of your body

SAVE THESE INSTRUCTIONS

Product Features

SHAVER PARTS

A. On/off button
B. Head & cutter assembly (head frame, cutter carrier)
C. Charging indicator
D. Head release grip
E. Head guard
F. Power cord

About Your Shaver

Dual Track Rotary Shaver

Charging

Before using, read the important safety instructions in front of the manual. Be sure that your hands, the shaver and the power cord are dry before charging your shaver.

• Be sure the shaver is switched off. Connect the shaver to the power cord, then the power cord to the outlet. Charge for at least 24 hours when using for the first time. The charging indicator light will glow while charging. Your shaver cannot be overcharged.
• Green LED will indicate the shaver is charging.
• When empty, the battery will be charged within 8 hours.
• Shaver will run up to 30 minutes on a full charge.
• Fully recharge for 24 hours every 6 months to maintain battery condition.
• The shaver can be attached to a outlet voltage of 120 VAC.

Remington recommends that you use your new shaver daily for up to four weeks to allow time for your hair and skin to become accustomed to the new shaving system

Shave

Before using, read the important safety instructions in front of the manual.

1. Switch the shaver on (A).
2. Hold the shaving head so both heads touch your face simultaneously (B).
3. Stretch the skin with your free hand so the hairs stand upright (C). Use short, circular strokes.
4. When finished, switch shaver off (A).

NOTE: Only apply light pressure on the shaving head while shaving (pressing too hard can damage the heads and may cause breakage.)

Shaving Tips

• Ensure your skin is dry and free of oils.
• Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping.
• Always hold the shaver at a right angle to the skin so that both heads are touching the skin with equal pressure.
• Use moderate to slow, circular stroking movement.
• The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line.
• Dry operation only.

Cleaning and Care

NOTE: When cleaning your shaver, make sure the shaver is turned off and disconnected from the power cord.

CAUTION!

• This shaver is NOT washable or water resistant. Do not clean or use under running water.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver.
• Do not wrap the cord around the appliance.
• Always store this appliance and cord in a moisture-free area. Do not store it in temperatures exceeding 140°F (60°C).
• Detach removable power cords from appliance for storage.

NOTE: This appliance does not contain any user-serviceable parts.

Daily Cleaning:

1. Clean the top of the shaver first. Use the brush supplied. (Diagram D)
2. Grasp tabs on both sides of the hairpocket. A better grip will be achieved if your hands are dry. (Diagram E)
3. Use the brush to clean the inside of the shaving head unit carefully. (Diagram F)
4. Clean the hairpocket carefully with the brush. (Diagram G)
5. Place the shaving unit back onto the shaver. (Diagram L)

Monthly Cleaning:

1. Perform Daily Cleaning steps 1-2 first.
2. On the underside of the shaving unit, turn the center switch to the left to release the frame from the shaving unit. (Diagram H)
3. Take the 2 shaving heads (cutters & guards) carefully out of the shaving unit. Clean the cutters and guards with the supplied brush. (Diagrams I & J)
4. After cleaning, place the shaving heads back into the shaving unit.
5. Put the frame back into the shaving unit and lock it in place by turning the switch to the right. (Diagram K)
6. Place the shaving unit back onto the shaver. (Diagram L)

NOTE: If you clean the shaving unit with alcohol or another degreasing agent, you need to lubricate the guards with one drop of sewing machine oil after cleaning. It helps to increase the lifespan of the shaving heads.

Always keep the protective head guard on the shaving head when the shaver is not in use.

Battery Removal/Disposal

When your rechargeable shaver reaches the end of its useful life, the Ni-MH batteries must be removed from the shaver and be recycled or disposed of properly in accordance with your state and local requirements. If this is not required by law, you may elect to dispose of the shaver with the batteries.

CAUTION! Do not put in fire or mutilate your batteries when disposing as they may burst and release toxic materials. Do not short circuit as it may cause burns. Dispose of properly in accordance with your local and state requirements.

How to Remove the Rechargeable Batteries:

1. Unplug the shaver.
2. Run the shaver until the motor stops.
3. Grab the tabs on each side of the hairpocket to remove the shaver head.
4. Using a small cross head screwdriver remove the screw inside the hairpocket.
5. Pull or gently pry apart the front half of the shaver to expose the 2 screws.
6. Unscrew the 2 screws that hold the rear housing.
7. Remove the rear housing.
8. Pull out the circuit board. Cut the connection plate on both ends of the battery.
9. Dispose of the battery with care.

Warranty

Limited Two-Year Warranty

Spectrum Brands, Inc. warrants this product against any defects that are due to faulty material or workmanship for a two-year period from the original date of consumer purchase. This warranty does not include damage to the product resulting from accident or misuse.

If the product should become defective within the warranty period, we will replace it free of charge. Return your product and sales receipt with your name, address and day time phone number to: Remington Returns Center, 507 Stokely

Dr., P.O. Box 1, DeForest, WI 53532. For more information call 800-736-4648 in the U.S. or Canada.

Warranty excludes: Heads and cutters

KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY PURPOSES.

This warranty does not cover products damaged by the following:

• Accident, misuse, abuse or alteration of the product
• Servicing by unauthorized persons
• Use with unauthorized accessories
• Connecting it to incorrect current and voltage
• Any other conditions beyond our control

No responsibility, obligations, or liability is assumed for the installation or maintenance of this product.

SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO THREE YEARS FROM DATE OF ORIGINAL PURCHASE.

This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province. Some states do not allow the exclusion or limitation of incidental, special or consequential damages. This warranty shall not be valid where it is contrary to U.S. and other applicable laws, or where the warranty would be prohibited under any economic sanctions, export control laws, embargos, or other restrictive trade measures enforced by the United States or other applicable jurisdictions. This includes, without limitation, any warranty claims implicating parties from, or otherwise located in, Cuba, Iran, North Korea, Syria and the disputed Crimea region.

Spectrum Brands, Inc. Money-back Offer

If within 30 days after you have purchased your Remington® branded product from an authorized source, you are not satisfied and would like a refund, return it with the sales receipt indicating purchase price and date of purchase to the retailer from whom it was purchased. Spectrum Brands, Inc. will reimburse all retailers who accept the product within 30 days from the date of purchase. If you have any questions concerning the money-back guarantee, please call 800-736-4648 in the U.S. or Canada.

Remington Guarantees Satisfaction After 30 Days!

**Remington 60-Day Money Back Guarantee***

If within 60 days after purchasing any Remington® product, you are not completely satisfied and would like a refund, return it with the original dated sales receipt directly to Remington and receive a full refund.* For questions concerning the money-back guarantee, please call 800-736-4648 in the U.S. or Canada.
Applies to U.S. and Canadian customers’ returns only.
**Terms and conditions apply.

1. Refund will be in the form of a check issued in U.S. Dollars and will be provided only if all Terms and Conditions are met.

2. The following items must be returned to Remington and postmarked no later than 60 days after purchase of the Remington® product:
   a. The Remington® product;
   b. The original sales receipt indicating price and date purchased; and

3. The completed 60-day money back guarantee form located at RemingtonProducts.com/60day.

4. In addition, Remington, in its discretion, must determine that the returned product was used in accordance with the instruction booklet (included with the product at the time of purchase).

5. Returns should be mailed prepaid (no collect returns accepted) to:
   Remington 60-Day MBG 507 Stokely Drive, Box 1 DeForest, WI 53532

6. Refund does not include postage costs for the return of the product, but will include applicable taxes paid by customer, if any.

7. No responsibility will be accepted for late, lost, stolen, misdirected or damaged product.

8. Please allow 4–6 weeks to receive your refund by check.

At the end of this product’s life, you can mail it to Spectrum Brands at 507 Stokely Drive, Deforest, WI 53532 marked “Product Takeback: Please Recycle!”

120 VAC 60 Hz , TYPE: R95A

Questions or comments

Call 800-736-4648 in the US or Canada or visit www.RemingtonProducts.com

Dist. by : Spectrum Brands, Inc., Middleton, WI 53562
Dist. by : Spectrum Brands Canada, Inc.
255 Longside Drive, Unit 101
Mississauga, ON L5W 1L8

® Registered Trademark and TM Trademark of Spectrum Brands, Inc. © 2022 Spectrum Brands, Inc., All rights reserved. 2/22 29131

Made in China.
T22-0001245-C

References

• Home | Remington®
• Return Policy & Money Back Guarantee | Remington®
• Home | Remington®

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>