Shenzhen Xian Da Cheng Electronics XD-W-007 Wireless Charger + Charging Magnetic + Phone Holder User Guide
- June 5, 2024
- Shenzhen Xian Da Cheng Electronics
Table of Contents
Shenzhen Xian Da Cheng Electronics XD-W-007 Wireless Charger + Charging
Magnetic + PhoneHolder
Product use
-
Insert the power adapter TYPE-C head into the power Jack behind the base.
- Large USB Output port
- Equipped with three magnetic Head
-
Wireless Charger Charging Magnetic Phone Holder
Connect part 1 to part 2 as prompted above.
Components 1 and 2 can be connected separately to meet the requirements of the adapter. -
Magnetic suction connector connected to mobile phone
Mobile phones that do not have wireless charging function need to be plugged into the equipped magnetic suction connector, and then the mobile phone can be recharged in the charging slot of the vertical charger. -
Mobile phones with wireless charging function can be charged wirelessly by horizontal screen vertical screen.
XD-W-007
Wireless Charger +Charging Magnetic + Phone Holder
- Vertical wireless charger XD-W-007,can charge devices such as smart watches or mobile phones that meet the Ql wireless charging standard.
- XD-W-007 can charge any cell phone that meets the size specification. (need to be matched with the coresponding magnetic suction connector)
- XD-W-007 can support up to 15W (max)power to charge the equipment.
- XD-W-007 can get rid of the shackles of charging lines, conveniernt and fast to dharge the equipment.
- XD-W-007 can be used as the horizontal screen/vertical screen bracket of the mobile phone,and can be charged while using it.
Thank you for using XD-W-007. in order to easily experience the product!
we are equipped with detailed instructions for the use of the product, from
which you can get the introduction of the product, the method of use, etc,
before you use this product, please read the manual carefully,if there are
printing errors or translation errors forget the understanding of the majority
users.
In order for users to ensure good performance when using this product correctly,.Please read carefully and abide by it.
- Do not disassemble the product by yourself so as not to be electrocuted.
- Do not place the product on an unstable desktop when you use it,so as not to drop the product and damage it.
FCC statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interterence, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
imits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could vOid the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies ith FCC RE radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.