Shenzhen Inateck Technology KB02012 Detachable Keyboard for iPad-iPad Air-iPad Pro User Manual

: June 3, 2024
: Shenzhen Inateck Technology

Table of Contents

Shenzhen Inateck Technology KB02012 Detachable Keyboard for iPad-iPad
Product Overview
How to pair an iPad
Function Keys
How to check battery status
FAQS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Shenzhen Inateck Technology KB02012 Detachable Keyboard for iPad-iPad

Air-iPad Pro

Product Overview

Note: To ensure that the iPad sleeps and wakes normally when close/open the keyboard case, please make the edge of the keyboard in line with the indication line on the support panel.

How to pair an iPad

Step 1: Install iPad onto the Bluetooth keyboard
Step 2: Toggle the power switch to ON, and the Bluetooth keyboard starts.
Step 3: Press the “Connect” key on the keyboard to enter Bluetooth pairing mode, when the Indicator 2 will flash in blue.
Step 4: On the iPad, select Settings- Bluetooth- On.
Step 5: The iPad will display “Inateck KBO2012” as an available device.
Step 6: Select “Inateck KBO2012” on the iPad.
Step 7: Indicator 2 goes off, which means the keyboard has been paired with iPad successfully.

Note

After one successful paring, the Bluetooth keyboard and the iPad can be automatically paired in future. However, when interference exists or unstable Bluetooth signal on iPad, the automatics paring might fail. In that case, please do as following. a. Delete all Bluetooth pairing record related to KB02012 on your iPad b. Turn off Bluetooth on iPad C. Follow How to pair an iPad’ to connect.
If iPad reminds: Connection Unsuccessful, Make sure Inateck KB02012′ is turned on and in range. Please follow the steps below to reconnect.
- Delete all Bluetooth pairing record related to KBO2012 on your iPad
- Turn off Bluetooth on iPad
- Follow ‘How to pair an iPad’ to connect.
After one successful paring, the Bluetooth keyboard can pair with the iPad automatically when being used for the next time.

Function Keys

Note

Press and hold the command key to see shortcuts in any app that supports them.
if you want to use Caps Lock Key in normal to Switch’s the case of alpha Characters, please follow the steps to change the iPad settings. Find General-Keyboard-Hardware Keyboard: TURN OFF Caps Lock and Switch to/from Latin
Double click might generate full stop punctuation on iPad. If you encounter such condition while typing Space key, please follow the steps below to change the iPad settings. Find General-Keyboard-Hardware Keyboard: TURN OFF “” Shortcut.

How to check battery status

Press simultaneously, and judge the battery level by the flash times of Indicator 4

Recharging

When the battery level is low, the indicator will flash in blue. If all the indicators are off, it means the battery is completely drained. Under both situations, the keyboard should be recharged. The required charging voltage is 5V with the current under 250mA. A Current control chip is set Inside the keyboard for overcurrent protection. You can recharge the keyboard by using an ordinary phone charger or connect it to the USB port of a computer that regularly outputs voltage at 5V. The keyboard can be fully recharged in approximately 3-4 hours. The indicator light goes off when the battery is full. Note You can use the keyboard while it is being recharged.

Sleeping mode

The keyboard will sleep automatically if there is no operation on it for 30 minutes. Wake it up by pressing any button. Under sleep mode, Bluetooth will disconnect automatically, and you can build reconnection by pressing any key.