Bestway 65346 Hydro Force Sup Board Instruction Manual
- June 5, 2024
- Bestway
Table of Contents
65346 Hydro Force Sup Board
Instruction Manual
Visit: www.bestwaycorp.com/support
Warning
IMPORTANT SAFETY INSTRUCTIONS
Read the manual and follow the instructions relating to safety tips, correct
and complete product assembly, setting into service, use, and maintenance. For
your own safety, always heed the advice and warnings in these instructions.
Non-compliance with these operating instructions may expose you to serious
danger or death. Only use the product in the places and conditions for which
it is intended.
Stand-up Paddling is a dangerous sport. The use of this product exposes the
user to unexpected risks, dangers, and hazards.
Users should realize and understand these risks. The use of this product
implies respect for the safety instructions described in the manual.
Do not exceed the maximum recommended number of persons.
Regardless of the number of persons on board, the total weight of persons and
equipment must never exceed the maximum recommended load.
Do not use this product if you are under the influence of alcohol, drugs, or
medications.
Life-saving devices such as life jackets and buoys should be pre-inspected and
used at all times. Always paddle with an experienced partner when using this
product.
Tell your sail routes and time schedule to your partner.
Check the weather forecast first to know the marine environment and weather
conditions before starting. Bad weather and the marine environment are very
dangerous. Never use this product in conditions that are beyond your ability
(such as but not limited to, high surf, riptides, currents, or river rapids)
Use the product near the shore and beware of natural factors such as wind,
tidewaters, and tidal waves. BE AWARE OF OFFSHORE WINDS AND CURRENTS.
Before every use, carefully inspect the product for signs of wear or leakage
to ensure everything is in good condition. Please do not use the SUP if you
find any damage. Do not surf in unfamiliar water areas.
Beware of potential harmful effects of liquids such as battery acid, oil, and
petrol. These liquids may damage the product. Inflate according to the rated
pressure on the product or it will cause overinflation and/or an explosion.
Stay balanced. Uneven distribution of loads on the board may cause the board
to overturn which could lead to drowning.
Know how to operate this product. Check your local area for information and/or
training as needed.
Inform yourself about local regulations and dangers related to surfing,
boating, and/or other water activities.
SAVE THESE INSTRUCTIONS
Technical Specifications
Item
| Inflated Size| Recommended Working pressure| Maximum Load
Capacity| Maximum Number
of persons|
SPARE PART
---|---|---|---|---|---
65346
|
3.05m x 84cm x 15cm
(10′ x 33″ x 6″)
|
1.03bar (15psi)
|
130kg (287lbs)
|
1 Adult
| 
Part No.| Description| QTY| 65346
---|---|---|---
1| Surf Board| 1| P05273
2| High-Pressure Hand Pump| 1| P05297
3| Oar| 1| P05291
4| Safety Rope| 1| /
5| Wrench| 1| /
6| Polyester 3-ply patch| 1| /
7| Bag| 1| /
8| Elastic Cord| 1| /
9| Fin| 1| /
Installation of the SUP
1. Take out the SUP from the bag (Fig 1).
2. Unfold the SUP (Fig 2).
3. Connect the inflation hose to the inflation valve (Fig 3).
4. Inflate the SUP to 1.03 bar (15 psi) (Fig 4).
5. Close the valve before use (Fig 5).| 6. Install the safety rope (Fig 6 &
7).
7. Install the fin (Fig 8).
8. Assemble the oar (Fig 9).
9. Completion (Fig 10).
---|---
Usage of the SUP
- Adjust the length of the oar before using the SUP (Fig 1).
- Kneel on the board (Fig 2).
- Gradually stand up on one leg (Fig 3).
- Stand up with the other leg and keep your hands on the board (Fig 4).
- Maintain balance with a paddle (Fig 5).
- Keep knees slightly bent, increase the balanced buffer, and start rowing (Fig 6).
- Begin to row after standing up (Fig 7).
****Extended exposure to the sun can shorten the lifespan of your SUP.
We suggest not leaving SUPs in direct sunlight for more than 1 hour after use.
Maintenance and storage of the SUP
- Disassemble the fin (Fig 1).
- Deflate the SUP by pushing on the pin and rotating clockwise. (Fig 2).
- Fold the SUP, but not more than 10 cm every time (Fig 3).
- Pack the SUP (Fig 4).
- Insert the SUP in the bag (Fig 5).
**** Store in a cool, dry place and out of children’s reach. Do not unfold this product when the temperature is low. The product should be at room temperature (over 20°C) for 24 hours before inflation.
Repair
For support please visit us at:
bestwaycorp.com/support
©2020 Bestway Inflatables & Material Corp.
All rights reserved
Bestway Inflatables & Material Corp., No.3065 Cao An Road, Shanghai,
201812, China.
Manufactured, distributed, and represented in the European Union by
Bestway (Europe) S.r.l., Via Resistenza, 5, 20098 San Giuliano Milanese
(Milano), Italy
Distributed in North America by
Bestway (USA) Inc., 3411 E. Harbour Drive, Phoenix, Arizona 85034, United
States of America
Tel: +86 21 69135588 (For U.S. and Canada)
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea,
Pudahuel, Santiago, Chile
Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit
2/98-104 Carnarvon St Silverwater, NSW 2128, Australia
Tel: Australia: (+61) 29 0371 388; New Zealand: 0800 142 101
Exported by
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited
Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon,
Hong Kong
www.bestwaycorp.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>