KARCHER T 150 Hard Surface Cleaner Instruction Manual

: June 5, 2024
: Karcher

Table of Contents

Safety instructions
Description of the Appliance
Application
Troubleshooting
General information
Documents / Resources

makes a difference
T 150

Register
your product
www.kaercher.com/welcome

Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners.

Safety instructions

Please observe the safety instructions of your high-pressure cleaner.
Only trigger the high-pressure jet at the high-pressure gun if the T-Racer is located on the surface to be cleaned.
There must be no persons in the immediate vicinity of the cleaning head.
Beware of the recoil! Ensure a stable position and firmly hold the high-pressure gun with the extension tube.
When working on the T-Racer, disconnect it from the high-pressure gun.

Description of the Appliance

When unpacking the product, make sure that no accessories are missing and that none of the package contents have been damaged. If you detect any transport damages please contact your dealer. Illustration A

Extension tube
Adapter
Casing
Rotor arm
High pressure nozzle

Proper use

The T-Racer is ideally suited for the cleaning of floor and wall surfaces made of different materials such as wood, plastic, concrete, tiles, and natural stone. Use the T-Racer for private households only.
This device is intended for use with the K 2 / K 3 high-pressure cleaner only.

Symbols on the machine

DANGER
Do not reach under the edge of the T-Racer during operation!

Application

Preparatory operations
Install the adapter in the casing.
Illustration B

Take the adapter into the opening of the casing.
Turn the adapter clockwise until it snaps into place.

Note
Onetime installation. The adapter cannot be unlocked anymore.

Cleaning floor surfaces
Fasten the T-Racer to the high-pressure gun using the extension pipe. Illustration C
Press the extension tube into the bayonet connection of the high-pressure gun, then turn by 90° until it locks into place.

Tips for cleaning

The T-Racer is not suited for scouring or scrubbing!
Outdoor surfaces should be swept before the TRacer is used to avoid damaging the high-pressure nozzles.
Guide the T-Racer over the surface without effort. Illustration D

CAUTION Do not run over protruding corners!

Troubleshooting

High-pressure cleaner does not build up the pressure or is vibrating.
→ Clean or replace high-pressure nozzle. Illustration E

Remove the clip.
Pull out the high-pressure nozzle.
Rinse the high-pressure nozzle with clean water, and replace if necessary.
Insert the nozzle.
Reinsert the clip.

General information

Tip
You can use the extension pipe with any Kärcher accessory.
Care
Use a moist cloth and clean the appliance after use.
Store the appliance in a frost free area.

Environmental protection
The packaging material can be recycled. Please do not place the packaging into the ordinary refuse for disposal, but arrange for the proper recycling.
Old appliances contain valuable materials that can be recycled. Please arrange for the proper recycling of old appliances. Please dispose of your old appliances using appropriate collection systems.
Notes about the ingredients (REACH)
You will find current information about the ingredients at:
www.kaercher.com/REACH

THANK YOU!
DANKE!
Register your product and benefit from many advantages.
www.kaercher.com/welcome
Rate your product and tell us your opinion.

www.kaercher.com/dealersearch
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28-40
71364 Winnenden (Germany)
Tel.: +49 7195 14-0
Fax: +49 7195 14-2212

http://kaer.ch/er/?l=TwSoJtl9IUOwZyAe1rHDyw