Shenzhen Kaduo Industrial CONTROL-001 RF Wireless Remote Instructions

Kaduo Industrial CONTROL-001 RF Wireless Remote
Instructions

Instructions

• Dimmer & Dynamic
• 8 Dynamic Effects
• 10-Level Dimmer
• 256-Grade PWM
• Speed Adjustable
• Card Type Remote
• Ultra Slim Design
• Smooth Dimmer Effect
• 1 to 1 Remote Paired
• Auto Save Function

1. Turn On/ Standby Press this key to turn on the unit or switch to standby mode. The unit will turn on and restore to its previous status at powering on the moment.
2. Lighting mode Switch to lighting mode from dynamic mode.
3/8/9. Dimmer Adjust Shortcuts Switch to 100%, 50%, or 25% brightness lighting mode.
4/6. Dynamic Mode Adjust Switch to dynamic mode from lighting mode or switch between different dynamic modes.
5/7. Speed Adjust Adjust the playing speed of dynamic modes. Press SPEED+ to increase speed and press SPEED- to decrease.
10/11. Brightness Adjust (Dimmer) Adjust lighting mode brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decrease.

Functions

Installing

1. Power Supply
   This unit accepts DC12Vto 24V power supply. The red cable should be connected to a positive and the black cable to the negative. Please select the proper power supply according to the LED application.

2. LED Output
   The red cable should be connected to the LED positive and the black cable to the negative. The peak output current is 6 A, please reduce the load if the main unit is overheating.
   CAUTION! Do not short circuit the LED output, this may lead to permanent damage!
   

3. Remote Control!
   Please pull out the insulating part before using it. The RF wireless remote signal can pass through a barrier, so it’s not necessary to aim at the main unit when operating. For proper receiving of the remote signal, do not install the main unit in closed metal parts. The remote battery is a 3V CR2025 type, please only replace it with the same type battery.

Specification

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>