Tianjinshi Bosanjiao Electronic Development T08Y2G4 Remote Controller User Guide
- June 5, 2024
- Tianjinshi Bosanjiao Electronic Development
Table of Contents
**Tianjinshi**
Quick Userguide
TO8Y-2G4 Remote Control Instruction
T08Y2G4 Remote Controller
- Code matching is required after the first use or change of battery.
- Load battery, remote light on, open the vehicle power until the light is flashed, and the code is set to OK.
- CODE is the backup key, SPEED is the speed adjustment key, and STOP is the brake key.
- Please replace the battery when the light of the remote controller flashes when pressing any key.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. FCC Warning: This device corn plies with part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
FCC Statement: This equipment has been tested and found to comply with
the limits for Class B digital devices, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RFexposure requirement
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>