Androidex JG-PL5000 Atomizing Sterilizer Instructions
- June 5, 2024
- Androidex
Table of Contents
**Androidex ** Atomizing sterilizer instructions
Thank you for buying our products Please read the product instruction carefully before use Please use correctly and safely
Specific operation
- Please open the package to confirm the product and its accessories
- Match the lower shell with the base, and rotate clockwise to lock it
- Turn the handle screw into position
- Match the upper shell with the lower shell, and lock it by clockwise rotation
- Put the product in a flat position and power it on
- Open the lid and add 5L water from the top
- After adding water, use tweezers to add special tablets for disinfection from above
- Connect the power adapter and power it on
- The voltage shall be 100V~240V(50Hz/ 60Hz)
- Touch the power switch to turn on the product
Cleaning and maintenance
- Before cleaning, be sure to cut off the power and unplug the power plug
- In order to avoid discoloration, thinner, toluene, acid detergent, kerosene, alcohol, and do not use chemical rags to wipe them.
- When not in use for a long time, please clean the body, put it in the original packing box after drying, and keep it in a place without moisture. When drying is insufficient, corrosion or failure will lead to rust
- When cleaning the water in the lower part, take the upper part away
- When cleaning the atomizing tablet, please wipe it gently with a brush or cotton swab
- Please use the tablets within 2 weeks after adding them
FCC ID: 2AXMKJG-PL5000
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>