MTMS 2AO3LB1347R24G Radio Control Vehicle User Manual
- June 5, 2024
- Mtms
Table of Contents
MTMS 2AO3LB1347R24G Radio Control Vehicle
GETTING TO KNOW YOLUR VEHICLE
CONTROLLER BATTERY INSTALLATION
CHARGING YOUR VEHICLE
NOTE: CHARGING USUALLY TAKES ABOUT 15 MINUTES FOR A 15-MINUTE RUN TIME. DO NOT CHARGE MORE THAN THIS. NEW BATTERIES ARE REQUIRED ON THE CONTROLLER ONCE RUN TIME STARTS TO DECREASE. WHEN THE BATTERIES ARE LOW, THE LED POWER INDICATOR WILL BEGIN FLASHING.
NOTE: AFTER 10 MINUTES OF INACTIVITY, THE CONTROLLER AND VEHICLE WILL GO INTO SLEEP MODE. ONCE IN SLEEP MODE, YOU MUST TURN THE VEHICLE OFF AND ON AGAIN, AND GO THROUGH THE LINKING PROCEDURE (SEE BELOW SECTION).
REMEMBER:
Before recharging the battery, wait 10-15 minutes to let the battery cool
down.
Never leave unattended while charging.
HOW TO LINK YOUR VEHICLE
OPERATING YOUR VEHICLE
TROUBLESHOOTING
PLEASE NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.