Industria Fueguina De Relojeria Electronica SMARTWAY T3 Mobile Phone User Guide
- June 5, 2024
- Industria Fueguina De Relojeria Electronica
Table of Contents
Industria Fueguina De Relojeria Electronica SMARTWAY T3 Mobile Phone
Device Design
To turn the device on, press and hold the POWER key for a few seconds.
Remove back case
-
This Device supports 2 Nano SIM Cards Remove the back case
Please use only your hands to open the back case (no tools of any kind). Please find a slot in the bottom right corner for this purpose -
Insert Nano SIM Card
-
Insert Battery
Charging Battery
Before you start using the Device for the first time you must charge the battery for 6 hours at least
Safety Information
Read all the safety information before using the device for the purpose of ensuring proper and safe use.
Warning
Follow the warning information provided below to prevent incidents such as
fire or explosion.
- Do not expose the device to physical impact or damage.
- Do not carry your device in your back pockets or your waist.
- Store the spare batteries ina suitable protective case.
- Use manufacturer-approved chargers, accessories, and supplies.
- Prevent the multipurpose jack from contacting conductive elements, such as metal or liquids.
- Do not touch the charger or the device with wet hands while the device is charging. Do not use the device in humid environments, such as baths or during aquatic activities such as.
- If any part of the device is cracked, broken or it overheats, stop using the device immediately and take it to a Kodak Service Centre.
- Do not turn on or use the device while the battery compartment IS exposed.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>