Leez ECB-PR70 Bluetooth Module User Guide
- June 5, 2024
- Leez
Table of Contents
- Leez ECB-PR70 Bluetooth Module
- Package LisT
- Tech Support
- Front GPIO 40PIN header Back System Spec
- FCC Modular Usage Statement
- RF exposure considerations
- Antennas
- Antennas
- Recycling and Environmental Information
- Restriction of Hazardous Substances
- Lithium battery notice
- FCC Statement
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Leez ECB-PR70 Bluetooth Module
IMPORTANT SAFETY INSTRUCTIONS
Notice: Product-related information is located at the bottom of your device.
- Read these instructions – All the safety and operating instructions should be read before this product is operated.
- Keep these instructions – The safety and operating instructions should be retained for future reference.
- Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.
- Follow all instructions – All operating and use instructions should be followed.
- Do not use this apparatus near water – The appliance should not be used near water or moisture – for example, in a wet basement or near a swimming pool, and the like.
- Clean only with dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacture’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding plug. A polarized plug has two blades with one wider than the other. A grounding plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at the point where they exit from the apparatus
- Only use attachments/accessories specified by the manufacturer.
- Unplug the apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- Minimum distances around the apparatus for sufficient ventilation is 20 cm.
- The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
- No naked flame sources, such as lighted candles, should be placed on the apparatus.
- The use of apparatus in moderate climates.
- WARNING: The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
- WARNING: The direct plug-in adapter is used as a disconnect device, the disconnect device shall remain readily operable.
- This lightning flash with an arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage” within the product’s. enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
- WARNING: To reduce the risk of electric shock, do not remove cover (or back) as there are no user-serviceable parts inside. Refer servicing to qualified personnel.
- The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance instructions in the literature accompanying the appliance.
This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it does not require a safety connection to the electrical earth.
Package LisT
- Mother Board
- Pub
- Adaptor(option)
- USB cable(option)
Notice:
The adapter requires DC5V @3A. Be sure to install a custom heatsink when
running under a large load. Must be used under normal temperature conditions.
External power supply is required for larger loads. Must use the standard wifi
antenna. Be careful not to reverse the power of the serial port and GPIO,
otherwise it will damage the motherboard.
It is recommended to use an electrostatic bracelet to prevent damage,
Please do not connect to interfaces other than USB, LAN, Audio, HDMI when
power is on.
Usage Step:
- From the website https://github.com/leezsbc/resources/wiki/Leez-P710 download the appropriate image.
- Burn the operating system to SD card or eMMC, (see the official website for the burning method Relevant detailed guidelines https://leez.lenovo.com).
- Connect the appropriate peripherals.
- USB 5V power connected to the power adapter.
Tech Support
-
https://leez.lenovo.com
Leez forum -
mail:leezinfo@lenovo.com
Front GPIO 40PIN header Back System Spec
Item
|
Description
---|---
Platform| Rockchip RK3399,Mali-T860 GPU
Memory| 4/2GB LPDDR4
Storage| eMMC 16GB(optional)
M.2| M.2 B-key Slot1, 3042, for 4G LTE
USIM| USIM slot1
Connectivity
| Ethernet: Native Gbps Ethernet
WiFi: 802.11a/b/g/n/ac, Bluetooth 5.0
Antenna*1: IPX Connector
Video Input| 2 4-Lane MIPI-CSI, dual ISP,
Video Output
| HDMI1: HDMI 2.0a, supports 4K@60Hz, HDCP 1.4/2.2, DP1(usb type c)
4-Lane MIPI-DSI*1
USB
| USB 3.0A1 + USB 3.0 Type c1, Support DP
---|---
USB2.02,Type-A ports
USB Type-C1: 5V Power input
Pin-header
| GPIO1: 40pin, 2.54mm pitch pin-header
23V/1.8V I2C, up to 13V UART, 1*3V SPI,
1SPDIF_TX, up to 83V GPIOs, 1*1.8V 8 channels I2S
GPIO2: 82pin, 2.54mm pitch pin-header
USB 2.0 Host 2 , led, pwr, reset, audio output
GPIO3: Serial Debug Port1, 4pin,2.54mm header
Key| PowerKey1
LED
| Power LED(Red)1
GPIO Controlled LED(Green)1
Others| RTC: 2 Pin 1.27/1.25mm RTC battery input connector,
Power| DC 5V/3A
Heat sink| Fanless cooling fin
FCC Modular Usage Statement
List of applicable FCC rules
FCC CFR Title 47 Part 15 Subpart C Section 15.247
FCC CFR Title 47 Part 15 Subpart E Section 15.407
Summarize the specific operational use conditions
This transmitter must not be co‐located or operating in conjunction with any
other antenna or transmitter.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed andused in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician for help.
RF exposure considerations
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This modular must be installed and operated with a minimum distance of 20 cm between the radiator and user body.
Antennas
Integral antenna with antenna gain 2dBi for frequency range from 2402MHz to
2480MHz and 1.3dBi for frequency range from 5180MHz to 5240MHz & 5745MHz to
5825MHz .The antenna is a detachable FPC antenna. Please use the same type of
antenna and the antenna gain should not exceed the specified value. Do not
replace other types of antennas without permission.
Label and compliance information
If the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This
exterior label can use wording such as the following: “Contains Transmitter
Module FCC ID: A5M-ECBPR70”
Antennas
The antenna design frequency bandis:2.4G/5.8GWIFI segment. 2400-2480MHz
5100-5850MHz Radiantefficiency2400-2480MHz:>45% 5100-5850MHz:>30%
Label and compliance information If this certified module is installed inside
the host device, then the outside of the host must be labeled with “ Contains
FCC ID: A5M-ECBPR70”.
Recycling and Environmental Information
Lenovo encourages owners of information technology (IT) equipment to
responsibly recycle their equipment when it is no longer needed. Lenovo offers
a variety of programs and services to assist equipment owners in recycling
their IT products. For information on recycling Lenovo products, go to:
http://www.lenovo.com/recycling
Important battery and WEEE information
Batteries and electrical and electronic equipment marked with the symbol of
a crossed-out wheeled bin may not be disposed as unsorted municipal waste.
Batteries and waste of electrical and electronic equipment (WEEE) shall be
treated separately using the collection framework available to customers for
the return, recycling, and treatment of batteries and WEEE. When possible,
remove and isolate batteries from WEEE prior to placing WEEE in the waste
collection stream. Batteries are to be collected separately using the
framework available for the return, recycling, and treatment of batteries and
accumulators.
Country-specific information is available at:
http://www.lenovo.com/recycling
Restriction of Hazardous Substances
Directive (RoHS) European Union RoHS Lenovo products sold in the European
Union on or after 3 January 2013 meet the requirements of Directive 2011/65/EU
on the restriction of the use of certain hazardous substances in electrical
and electronic equipment (“RoHS recast” or “RoHS 2”). For more information
about Lenovo progress on RoHS, go to: http://www.lenovo.com/social_
responsibility/us/en/RoHS_Communication.pdf Plastic Bag Notice
DANGER: Plastic bags can be dangerous. Keep plastic bags away from babies
and children to avoid danger of suffocation.
Lithium battery notice
DANGER: Danger of explosion if battery is incorrectly replaced. When
replacing the lithium coin cell battery, use only the same or an equivalent
type that is recommended by the manufacturer. The battery contains lithium and
can explode if not properly used, handled, or disposed of.
Do not:
- Throw or immerse into water
- Heat to more than 100°C (212°F)
- Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
The following statement applies to users in the state of California, U.S.A.
Perchlorate material: Special handling may apply. See
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Export Classification Notice
This product is subject to the United States Export Administration Regulations
(EAR) and has an Export Classification Control Number (ECCN) of 5A992.c. It
can be re-exported except to any of the embargoed countries in the EAR E1
country list.
Compliance Information The latest electronic compliance and environmental
information is available from the Lenovo Web sites.
To view compliance information go to:
http://www.lenovo.com/compliance
To download environmental information go to:
http://www.lenovo.com/ecodeclaration
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
SAR Statement
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Manufacturer: Lenovo (Beijing) Limited
Location: 201-H2-6, Floor 2, Building 2, No.6 Shangdi West Road, Haidian
District, Beijing, China 100085
Operating temperature :0 ℃ to +60℃
We declare that this device is in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.
Our product do not contain the AC/DC adapter. You need to purchase the DC
5V/3A in compliance the directive 2014/30/EU.
The adapter shall be installed near the equipment and shall be easily
accessible.
Wi-Fi
Operation Frequency: 2412MHz~2472MHz
Maximum Power: 15.53dBm(E.I.R.P.)
References
- dtsc.ca.gov/hazardouswaste/
- Regulatory Compliance | Lenovo US
- Lenovo Eco Declaration Compliance Information | Lenovo US
- lenovo.com/social_
- Leez SBC · GitHub
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>