E-lluminate A5 Smart Lighting Instruction Manual
- June 5, 2024
- E-lluminate
Table of Contents
E-lluminate A5 Smart Lighting
IMPORTANT INFORMATION
- Do not roll up the light strip during installation, as it may melt.
- Do not cover the light strip as this may cause it to overheat and melt.
- Do not immerse the light strip in the water, or use it near water or other liquids.
- Only use the provided power adapter, controller or dimmer, as the power of the light strip cannot be higher than the maximum power of the adapter, controller or dimmer.
- Only use the provided hanger or clip to protect the light strip. Do not use staples, nails or other fixings on this product or its wires, as they may damage the insulation.
- Risk of fire – do not replace the plug, the fuse in the plug should not be removed.
- Discard the product if the plug is damaged.
- Please be aware of static during the installation and use of the product.
- Do not touch the product with sharp tools.
- Ensure that the installation site is dust-free, clean, and smooth, otherwise, the product will not adhere to the surface.
- Avoid bending the product at the point of any LEDs.
COMPONENTS
- 10m Smart LED Light Strip
- Power Adapter
- WiFi LED Controller
- Bag of Screws & Fixings
UPDATING YOUR FIRE
Important
If your fire has an Update warning as shown above, it is important that the
fire is fully updated in order for the smart lighting to work. Select the
update icon to update the fire, do not turn off the fire until it has
completed updating, this can take up to 10 minutes. Once completed you can
continue with the installation.
INSTALLATION
Remove the protective cover from the end of the LED Light Strip, then connect it to the WiFi Controller making sure to line up the white and red arrow as shown above. Connect the WiFi Controller to the power adapter, don’t connect to the mains power during installation.
- Clean the surface before applying the LED strip.
- Peel off the adhesive backing as you fix the LED strip to the surface.
- Press the strip onto the surface firmly.
- Reinforce the LED strip with the provided screws and clips.
- If you need stronger adhesion to your surface, you can use the foam stickers provided.
- Press firmly on the LED strip
CONNECTING THE LEDs TO THE APP
- Once the LED strip is plugged into the mains and turned on. Go to the E-Smart app, then select Settings on your Home Page.
- In Settings go to Other Options.
- Click on Search Mood Light, and wait for the app to connect to the LED strip. This will take approximately 1 minute.
- Once connected, the mood light option will show on your Home Page, as above.
CONTROLLING THE LEDs
- The LED strip can be turned off and on by selecting the light bulb button.
- The brightness of the LEDs can be adjusted with the brightness slider, slide it left to dim the lights, and right to increase the brightness.
- The color of the LEDs can be chosen using the color selector, or the color picker on the bottom right.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>