Visteon H2WCLUSTER Digital Cluster User Manual
- June 5, 2024
- Visteon
Table of Contents
Visteon H2WCLUSTER Digital Cluster
Customer Information
Instructions to access to the electronic labeling
- IGN ON
- Opening animation begins and completes after 3sec.
- Main screen appears like below.
- Long press Right S/W then enters Setting mode
- Setting screen appears like below and FUCTION is selected at the beginning.
- Short press Down S/W at three times then SERVICE is selected
- Short press Right S/W then MAINTENANCE is selected at center of the screen.
- Short press Down S/W at three times then REGULATORY is selected.
- Short press Right S/W then the REGULATORY screen shows up.
Declaration of Conformity
- Model Name: 2W Cluster
- Type of product: Digital Cluster with BTLE
- Brand Name: Visteon Corporation
One Village center drive, Van Buren Township 48111-5711 Michigan
United States of America
Simplified EU DoC: Hereby, Visteon Corporation declares that the radio
equipment type 2W Cluster is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following
internet address: http://www.visteondocs.com/
Hereby, Visteon Corporation, declares that this 2W Cluster is in compliance
with the essential requirements and other relevant provisions of Directive
2014/53/EU.
The following information shall also be included in the case of radio equipment intentionally emitting radio waves:
- a. Frequency band : 2.4 GHz
- b. Maximum radio-frequency power transmitted in the frequency band(s) in which the radio equipment operates. Max output power = 3.5 dBM
(U.S.A. and Canada)
FCC
FCC ID: NT8-HONDA2WCLUSTER
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- The device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Class B device notice
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure safety
This device complies with the FCC RF exposure limits and has been evaluated in
compliance with mobile exposure conditions.
The equipment must be installed and operated with minimum distance of 20 cm of
the human body.
ISED CANADA
IC: 3043A-HONDA2WCLUSTER
This device complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- The device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RF exposure safety
This device complies with ISED RF exposure limits and has been evaluated in
compliance with mobile exposure conditions.
The equipment must be installed and operated with minimum distance of 20 cm of
the human body.
CAN ICES-003
This Class B digital apparatus complies with Canadian ICES-003.
(Translation: This equipment is not entitled to protection against harmful interference and may not cause interference in duly authorized systems)
- Product name: Digital Cluster with BTLE
- Model name: 2W Cluster
- Trade mark: Visteon Corporation
- NCC caution statement:
‘Any changes or modifications are not allowed. The product is subject to not cause harmful interference to radio communications and air flight safety. If this equipment does cause interference, which can be determined stop shipping till the product is improved.
This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation.’
In Chinese language, the warning would be:
Ukraine *Owner’s manual Must be in Ukrainian language and include safety information
(It means that, as this radio equipment has the possibility of radio
interference, this equipment cannot be used for any services related to human
life safety)
KC logo along with the following information (Conformity assessment
information:
- Company name of Applicant: Visteon Corporation
- Manufacturing date: yyyy/mm/dd
- Manufacturer/ Country of origin : USA
- Equipment name/ Model name : 2W Cluster
- Conformity assessment number : XXXXXXXXXX