Vietnam Kingsun Q05W1 Wireless Charger Instruction Manual
- June 5, 2024
- Vietnam Kingsun
Table of Contents
Q05W1 Wireless Charger
Instruction Manual
Description
Wireless charger for smartphones under the Qi-standard.
Easy to charge your phone without cables, just put your phone on the charging
plate. Please keep reading the following safety notes before use or
examination.
Primary technical specification of the marking on the product
Input Voltage: DC 5V/1.5A
Charging Frequency: 110-205 kHz Charging Distance: <6mm
The interface type: Micro b Pin USB
Operation instruction
-
The product is used only indoors or at a dry location.
-
Don’t store or use this product in erosional conditions.
-
The temperature around the product must be kept as indoor temperature and should avoid overheating or cold it would affect the characteristic and working life.
-
According to the technical specification of the product, the wireless charger should be connected with an AC adaptor with the requested spec and specified smartphones.
Please notice if input voltage & current complies. A qualified AC adaptor is recommended -
Way to work
1)When the power is switched on, the red and blue LED blink three times then extinguish.
2)When putting on the phone to charge, the blue light will go out after the 6S and continue to charge until it is full and the light is not on
3)Protection of foreign object detection, over-heat protection, overload protection, etc. Until normal. -
If you have any technical questions, please do not hesitate to consult the supplier directly.
Conforming to a standard
FCC ID: 2AWX9-C105W1
IC: 11972A-Q10W1
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/1V technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>