Shanghai Ogino Biotechnology WRGB II Series LED Lighting System User Manual
- June 5, 2024
- Shanghai Ogino Biotechnology
Table of Contents
WRGB II Series LED Lighting System
WRGB II Series
LED Lighting System Manual
Please read and fallow instruction before starting use the product!
Subject to technical changes.
This device requires an App to be used on your phone. Please
download and install it as follows.
Shanghai Ogino Biotechnology Co,, Ltd.
wwwachihiros.cn
facebook.com/chihirosaquatic
Manufacturer:
Shanghai Ogino Biological Technology Co.,Ltd. CIX! Branch
No.1999 Xisanhuan Road, Cixi City, Ningbo, Zhejiang, China
E-mail: chihiros@chihiros.cn Tel: +86-574-63213987
SAFETY INSTRUCTIONS
- Never look directly into the LED-Light! It may cause danger to your eyes!
- Always unplug the power before maintenance work or cleaning.
- For using with AC 100-240V ~ 50/60 Hz only.
- For indoor use only.
- Never use the light under the water.
- Use the light only after the installation is completed.
- The power plug should always be within easy reach so that power could be turned off instantly in case there should be an emergency failure after installation.
- Never cover up the LED light and power adapter for the best cooling.
- For you own safety, we recommend to form a drip loop with the connection cable to prevent any water running along the cable from intruding into the socket.
- Do not use the product if any part of connection cable or power adapter is damaged. The damaged parts must be replaced before using again. Use only original Chihiros parts.
- Children above the age of 8 or individuals with reduced physical, mental or sensory capacities or lack of experience or knowledge may be allowed to use the product, only provided they are supervised or have received instruction in the safe use of the product and therefore understand the risks involved. Do not allow children to play with this product. Do not allow children to clean or conduct user maintenance without supervision
- Do not dispose of this product as normal household waste. Take it to your local refuse collection site.
– If the LED-Modul drops into the water by accident, please unplug the
power immediately! Make sure the LED-Modul is fully dried out before
using again.
Never put the power adapter in or above of the aquarium cover.
The water tank should be covered by a cover in case of using a CO2-Diffuser
or air pumps. The LED-Modul is protected by plexiglass, nevertheless it
should not be in contact with any water drops.
“The LED-Light must always be at least 60mm above the water surface.
– Never use the LED-Light in an aquarium cover.
The LED-Light is very hot during the application. Please do not touch it
before the power is unplugged and fully cooled
PACKAGE CONTENTS
- LED-light body
- Light stand
- Screws and inner hexagon spanner
- Power adapter and plug
- Pen controller
APP CONNECTION
Please make sure that the Bluetooth® and position switch on the phone are
turned on before use.
TECHNICAL SPECIFICATIONS
Power Input AC100 – 240 V 50/60 Hz
Power Output DC36V
LED lifetime Over 50,000hrs
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation, changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be
installed and operated with minimum distance of 2cm the radiator your body.
This device
and its antenna(s) must not be co-located or operation in conjunction with any
other
antenna or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>