Peag Dba Jlab Audio JBuds Dongle User Manual
- June 5, 2024
- Peag Dba Jlab Audio
Table of Contents
Peag Dba Jlab Audio JBuds Dongle User Manual
Product name: Dongle Product Model: JBdus Dongle FCC ID: 2AHYV-JEDGL1
-
RX (receiver) to enter EMI mode, first insert receiver 1 to be tested.Open EMI Test Software
-
Click “Please click to enter EMI test” to enter the 2.402GHz frequency point, and the interface is as follows
-
Continue to click “Please click to enter EMI test” and change the transmission frequency to 2.439GHz (empty carrier),
2.479GHz (empty carrier), 2.402GHz (with data), 2.439GHz (with data), 2.479GHz (with data) 16 channel data cycle, pure receive mode, 2.402GHz (empty carrier) cycle in sequence
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
FCC ID: 2AHYB-JEDGL1
IC Caution:
RSS-Gen Issue 5 “&” RSS-Gen numéro 5
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>