Shenzhen Yitequ Technology ET924 Electronic Cabinet Lock Instruction Manual
- June 5, 2024
- Shenzhen Yitequ Technology
Table of Contents
Shenzhen Yitequ Technology ET924 Electronic Cabinet Lock
Note:
Please install batteries and set up key cards before installing the lock to
cabinet. Video about how to set up admin card and guest cards:
https://youtu.be/WyEsZhTCQVc
Features
- The cabinet wooden door should not exceed 1.2 inches thick
- Multiple Unlock Mode: Single Unlock Mode, Dual Unlock Mode
- 4 x AAA 1.5V batteries required
- The batteries can last 8-12 months under normal use
- The sound alarm will alert when the batteries power is low
- The lock cannot be locked (keep open) if it is in low power status.
- 1 admin card and up to 12 guest cards can be set up on this lock kit.
Operation Instructions
-
Reset
Install 4 x AAA 1.5V Batteries. Press the reset button shortly until single- beep sounds. -
Select Unlock Mode (Single Mode is 1-card-swipe to unlock. Dual Mode is 2-card-swipes to unlock)
- Press the reset button shortly until you hear single-beep sounds. it is set in Single Mode.
- Press the reset button until you hear double-beep sounds, it is set in Dual Mode.
-
Set Up Admin Card
After resetting the lock, swipe a RFID card / tag. This first card / tag is configured as the admin card. -
Set Up Guest Cards
Swipe the admin card and then swipe new cards one by one. These cards are added as guest cards. -
Delete Cards
You can reset the lock if you want to delete the admin card and all guest cards. -
Low Voltage Alarm
It requires 4x AAA 1.5V Batteries to power on. In low battery power status, when you swipe the card to unlock, the voice alarm will alert (you can hear 8 beeps). And the lock cannot be locked (keep open). Please replace the batteries to make the lock work again.
Package Includes
1x Lock Body, 1x Latch, 1 set x Screws, 1 set x RFID Card/Tag, 1x Icon, 2x double-sided tape
If you have any question, please feel free to contact us by email: support@etekjoy.com
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>