Shantou Tonghan Electronics B39 Portable Wireless Headphones User Manual
- June 5, 2024
- Shantou Tonghan Electronics
Table of Contents
Shantou Tonghan Electronics B39 Portable Wireless Headphones
Product Parameters
| Model B39 | Use Distance |
|---|---|
| Version | V5.0 |
Voice Prompt
Stand-by|
180 hours
Time
Power Input| DC5V/200mA
Noise| CVC6.0
Reduction
Skip| Support
Pairing and Connection
- Keep the distance between the mobile phone and the headset within 1 m; the closer, the better.
- Press and hald the key for about 5 seconds, and then release it when the red and the blue lamps alternately blink. At this time, the headset has entered the paring mode.
- Enable the Bluetooth function of the mobile phone, search the Bluetooth equipment, select ‘ B39 ‘for paring and connection. After connection is successful, the blue indicating lamp of the headset slowly blinks.
Notes:
- The pairing mode will be maintained for 5 minutes. If pairing and connection are unsuccessful beyond 2 minutes, the headset will automatically switch to the stand-by mode.
- After pairing is complete, the headset and the handset will remember each other without pairing
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>