havit HV2861 KETT 316 Stainless Steel LED Deck Lights Instruction Manual
- June 5, 2024
- havit
Table of Contents
havit HV2861 KETT 316 Stainless Steel LED Deck Lights
| Product Specifications | Dimensions |
|---|---|
| Model No. | HV2861W |
Sample Wiring Diagram
Name| Kett
Material| 316 Stainless Steel
Colour| Stainless Steel
IP Rating| IP65
Input Voltage| 12v DC
Lamp Base| Built in LED
Protection Class| (Low Voltage)
Lamp Wattage| 1x 0.5w
Colour Temp| 3000k| 4000k| Blue
Lumens| 30lm| 35lm| 10lm
CRI| > 80
Wiring| Parallel
Dimmable| No
Warranty| 3 Years Replacement*
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- This fitting is not suitable for inground installation
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements,
Please visit website for most current installation instructions.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off )
- Make a hole where fitting is to be placed using dimensions provided on line drawings,
- Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting installed, wiring must be done in parallel.
- Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
- Solder all joins using solder and either a heat gun or butane gas torch.
- Cover connections using an adhesive lined heat shrink or gel cap to make connection watertight. Failure to do this will void warranty.
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Insert fitting into hole.
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
Contact Details:
143 Beauchamp Road| Tel: 02 9381 8300
Matraville NSW 2036| Fax: 02 9666 8881
Australia| Email: sales@havit.com.au
| Web: www.havit.com.au
Warranty Terms & Conditions
Additional Information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>