havit HV3206-SS316 Mini Reces 316 Stainless Steel Round Recessed LED Step Instruction Manual

Table of Contents

Product Specifications

HV3206 Dimensions havit-HV3206-SS316-Min- Reces-316-Stainless-Steel-
Round-Recessed-LED-Step-01

HV3216 Dimensions havit-HV3206-SS316-Min- Reces-316-Stainless-Steel-
Round-Recessed-LED-Step-02

This product must be installed by a qualified electrician according to AS/NZS 3000.
Ensure all electrical mains are disconnected before any installation.
Modification of this product will void any warranty.
Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
Aluminum and 304SS fittings must not be installed within 5km of any salt water environments.
All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on fitting. (Warranty does not cover Tea Staining)
Aluminum and 304SS fittings must not be installed within 5km of any salt water environments.
All O-rings and seals must be in place correctly to maintain warranty.
These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.

Make sure that the electrical circuit is free of voltage (master switch off )
Make a hole where fitting is to be placed using dimensions provided on line drawings,
Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
If installing into concrete, insert canister making sure it is flush with wall.
Connect the cable – If more than one fitting installed, wiring must be done in parallel.
Strip back the cable on both fitting and cable run and twist the positive cables together. Then connect neutral cables together
Solder all joins using solder and either a heat gun or butane gas torch.
Cover connections using an adhesive lined heat shrink or gel cap to make connection watertight. Failure to do this will void warranty.
Heat the heat shrink or crimp the gel cap making sure all connections are covered.
Insert fitting into hole or canister pushing on clips and inserting into position
If installed outside, apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Contact Details:
143 Beauchamp Road Matraville NSW 2036 Australia

Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au

**Warranty Terms & Conditions***

havit-HV3206-SS316-Min- Reces-316-Stainless-Steel-Round-Recessed-LED-
Step-03

Additional Information

| havit HV3206-SS316 Mini Reces 316 Stainless Steel Round Recessed LED Step [pdf] Instruction Manual
HV3206-SS316, Mini Reces 316 Stainless Steel Round Recessed LED Step, Round Recessed LED Step, LED Step, HV3206-SS316, Step
---|---