MARQUANT 929075 Wall Bracket Instruction Manual
- June 5, 2024
- MARQUANT
Table of Contents
MARQUANT 929075 Wall Bracket
SAFETY INSTRUCTIONS
- Read all the instructions and safety instructions carefully before installation. Contact your dealer if you have any questions.
- The product must only be used for its intended purpose and in accordance with these instructions. Incorrect installation can result in the risk of personal injury and/or material damage.
- Check that the wall can support the weight of the bracket and the product.
- Ask another person to help, or use a mechanical lifting device to lift and position the equipment.
- Tighten the screws firmly, but not too hard
- risk of material damage.
- The product is only intended for indoor use. Using it outdoors can result in personal injury and/or material damage.
WARNING!
Do not exceed the permitted maximum weight (max 40 kg) – risk of serious personal injury and/or material damage.
TECHNICAL DATA
- Max weight: 40 kg
- Weight: 3,5 kg
- Television size: 37-70″
DESCRIPTION
PARTS
Contact your dealer if any parts are missing or damaged.
FIG. 1
ASSEMBLY
FITTING THE DECOR PIECES
Screw the decor pieces on the wall plate.
FIG. 2
NOTE:
The slots in the decor pieces face down.
MOUNTING ON WALL
Mounting on wooden stud in wall
- Decide where on the wall the wall bracket is to be mounted.
- Mark out the position of the holes.
- Predrill the holes.
- Screw the wall plate on the wall with arrow pointing up.
FIG. 3
WARNING!
- Fasten the screws in the middle of the studs.
- Make sure to use suitable parts for the installation.
Mounting on concrete or brick wall
- Decide where on the wall the wall bracket is to be mounted.
- Mark out the position of the holes.
- Predrill the holes.
- Screw the wall plate on the wall with arrow pointing up.
FIG. 4
WARNING!
Check that the concrete is at least 35 mm thick to accommodate the concrete
anchors. Do not drill into mortar joints. Drill into the bricks or concrete
blocks, preferably at least 25 mm from the edge. Drill at low speed, not with
the impact drill function, otherwise this can produce a large hole on the
other side of the wall if the drill breaks through.
FITTING THE ADAPTER
- Place the adapters on the back of the projector, as close to the middle as possible.
- Screw the adapters to the television screen.
NO’IE:
Use suitable screws, washers and spacers for the actual screen model.
Depending on the model of television screen there are two different alternatives, no. 2 or 3.
- Top edge of screen.
- Alternative with television screen with flat back.
- Alternative for screen with indented back or for access to A/V inputs.
- Screw alternative 1.
- Screw alternative 2.
- Screw alternative 3.
- Screw alternative 4.
FIG. 5
WARNING!
- Tighten the screws firmly, but do not overtighten.
- Check at least every 3 months that the bracket is correctly mounted.
HANG UP THE SCREEN ON THE WALL BRACKET
-
Hang the screen over the top edge of the wall plate.
FIG. 6 -
Insert the locking edging to lock the rails.
-
Lock with a padlock (not included) to prevent theft.
FIG. 7
IMPORTANT:
- Two persons are needed to do this.
- Check that the screen is properly hooked on before releasing the screen.
- Check at least every 3 months that the bracket is correctly mounted.
USE
Adjust to the required angle by pulling/pushing the top or bottom of the screen.
FIG. 8
Documents / Resources
|
MARQUANT 929075 Wall
Bracket
[pdf] Instruction Manual
929075 Wall Bracket, 929075, Wall Bracket
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>