ITC TTR1834 Rectangle Table Top Instruction Manual
- June 5, 2024
- ITC
Table of Contents
ITC TTR1834 Rectangle Table Top
PARTS/TOOLS NEEDED
INSTALLATION CONSIDERATIONS
-
To avoid a hazard to children, account for all parts and destroy all packing materials.
-
Do not sit on or lean on a table, intended for use as a table only. The maximum load is 50 lbs distributed evenly.
-
The stiffness and rigidity of the floor mounting substrate has a direct effect on the sturdiness of the entire table system.
-
Recommend cleaning solutions: soap and water, Fantastic, Windex, 409 or Simple Green.
-
Mount the floor base into solid floor structure (wood, fiberglass, etc.) using #12 Phillips oval head screws.
-
Align the T-bolt on the bottom of the leg with the rectangular opening in the floor base. Insert the T-bolt
and use your foot to press down the black button the Floor Base. Next begin to turn the leg clockwise. After one turn, pull up on the leg to ensure that the T-bolt is secure in the floor base. Continue to turn the leg until the leg is seCure.
-
Install the table by aligning the table base to the leg and push down. To ensure the table base is secure to the table leg make sure the table base goes over the first black piece.
-
Removing The Leg& Table
To remove the table, press the button at the top of the post. *Twist top until
it releases from taper fit then lift until it pops off the post. 2 To remove
the leg, slide the base release tab, then fill the leg counter-clockwise and
lift gently until the leg removes from the base s Place cover on the floor
base when the leg is not in place.
For warranty information please visit www.itc-
manufacturersselect.com/warranty
ITC Incorporated 3030 Corporate Grove Dr. Hudsonville Ml 49426
Phone: 616-396-1355 www.itc-
us.com Doc #: MSTTR1834 Revision A: 12.04.19
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>