Franklin F7000 720-Watt Full Spectrum Led Grow Light Instruction Manual
- June 5, 2024
- FRANKLIN
Table of Contents
Franklin F7000 720-Watt Full Spectrum Led Grow Light
PACKAGE CONTENT
READ BEFORE INSTALLATION
WARNING:
To avoid damaging the LED chips, don’t touch the LED chips with you hands or
anything else during all the processes of opening the package, installing the
fixture and maintaining the fixture.
Mounting and installing of the LED fixture may only be executed by certified
sevice personnel, in accordance with the applicable local laws and
regulations,the installer is responsible for correct and safe installation
Ensure the local cabling can support the voltage and current requirements of
the LED fixture
Ensure the power cord and the controller cables not to touch any of the
lerails after assembly
CAUTION:
- UV emitted from this produc
- Possible hazardous optical radiation emitted from this product IR Emitted from this product
INSTALLATION
Please read the installation instructions thoroughly before installing.
NOTED: This lamp needs two people to complete the assembly.
Take caution when handling light bars.Ensure the LED array does not come in
contact with sharp objects or force that may damage the diodes.
-
Unfold the light(G), gently place it on floor, please noted the led side will be facing down.
-
Take out the power supply (F), find the preset point and clamp the power supply (F}to the waterfall mounting bracket(C), then connect the wire on the light and the wire on power supply(F).
If you want to install the Power supply(F) outside the lamp, please follow steps as below.
Take out the Power cord bracket(D) hook the hole in the Power supply(F) and hang it on the shelf.
-
Connect the lead wire on the driver and the lamp.
-
There are three installation ways for Step 4
Mode 1: Wire rope Installation
Take out the wire rope(A), hang the wire rope(A) on the circle of 4 lamp corners, Then need two people working together to lift the lamp.
REMARK: There is 1pc Contraction rope (B 88″) used to extend the cable.
Mode 2: Waterfall Mounting Bracket Installation
Take out the waterfall mounting bracket (C)and two men worked together to lift the lamp
SECTIONAL DIMMING FUNCTIO -
Be sure to hang from the center of the hanger to ensure a balanced fixture.-
Make sure all wire joints are connected well.Then you can turn on the light and use the dimmer swith to adjust the brightnes as whatever you want.
DAISY CHAIN FUNCTION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>