havit HV3277T-BLK Virsma Black Round LED Step Lights Instruction Manual
- June 5, 2024
- havit
Table of Contents
havit HV3277T-BLK Virsma Black Round LED Step Lights
Product Specifications
DIMENSIONS
MOUNTING BASE
Important Safety Issues
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminium and 304SS fittings must not be installed within 5km of any salt water environments.
- All o-rings and seals must be in place correctly to maintain warranty.
- These instructions may be updated at any time due to product improvements, Please visit website for most current installation instructions.
Steps for Installation
- Make sure that the electrical circuit is free of voltage (master switch off)
- Loosen allen screws on side of fitting and remove face and set aside.
- Install base plate to wall in desired location, Seal all holes including Cable entry and Mounting screws
- 240v Models, use wire with earth; connect the earth first, then live and neutral wire
- 12v DC Models – Using an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECTLY TO 240V
- Connect the cable – If more than one fitting installed, wiring must be done in parallel.
- Fitting is preset to 3000k, to change slide switch to desired colour temperature.
- Reattach face to base plate making sure allen screws are tight to avoid water penetration
- Apply silicon around edge of fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Contact Details
- Tel: 02 9381 8300
- Fax: 02 9666 8881
- Email: sales@havit.com.au
- Web: www.havit.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>