DEBUG 39421 Beach Wheelchair Instruction Manual
- June 5, 2024
- DEBUG
Table of Contents
39421 Beach Wheelchair
Instruction Manual
Thanks for your purchase of the DeBug Beach Wheelchair
We build the DeBug Beach Wheelchair with the highest quality materials,
keeping in mind the comfort and positioning of the rider.
If any repairs should be required, please do not attempt them without proper
technical training. Please contact your nearest distributor for any repairs,
or adjustments needed All information in this manual is subject to change
without prior notice. Please read the following few pages for Assembly and
Maintenance Instructions.
Thank-you
The De-Bug Mobility Products Team
USAGE & SAFETY
Safety Warning
DeBug Beach Wheelchair should not be used during inclement weather, dangerous
surf, rough ocean currents, rip tides and any other poor conditions.
The DeBug is not intended to be used in the water. It is not a flotation
device!
We recommended the chair be used only when a lifeguard is present. Safety
comes first!
Users must always be accompanied by a responsible, able-bodied adult.
Using your DeBug Beach Wheelchair
Always maintain control of your DeBug while in use. When the DeBug is not in
use, the safety brakes must be engaged to prevent the chair from moving
unexpectedly.
The DeBug was built to not tip over, even when used over uneven surfaces.
However, to ensure safety and prevent injury, the user must always wear the
seatbelt while using the DeBug. This is imperative to the user’s safety.
Do not use the components of the DeBug Beach Wheelchair for any purpose other
than what is intended. Do not have more than one person using the DeBug.
General Maintenance
It’s so easy to maintain your DeBug Beach Wheelchair! Just follow these simple
instructions, and you will be able to enjoy your chair year after year.
Rinse the chair off with clean water to remove any sand or debris after each
use.
The sling material is removable and machine washable.
Check tire pressure before each use. These wheels are meant to be pliable and
somewhat “soft” to the touch. Recommended tire pressure is 2.5 to 4 PSI. These
specifications are molded on each wheel.
If at any time you need to lubricate any part of the chair, DO NOT USE WD-40,
as it will attract dirt and sand, causing possible damage to the wheel
bearing/bushings. We recommend P.T.F.E Dry Lube, on all wearing components.
This dry film is a superior lubricant and repels debris and water, marine, and
performance parts stores likely stock this locally.
Have any questions, or need additional support? Please don’t hesitate to
contact us!
ASSEMBLY COMPONENTS
ASSEMBLING INSTRUCTIONS
- Slide on the leg support sling, and install the two 5/16”-18 adjustment knobs
- Slide on the footplate, and tighten the leg rest adjustment knobs
- Install the mid axle, tighten the two attaching 1/4”-20 bolts
- To install the backrest, slide the backrest down on the chair frame and attach using the two 1/4”-20 bolts
- The rear suspension may be attached by 0inserting the rear suspension tension bolt.
This bolt should be tight during use.
DISASSEMBLING INSTRUCTIONS
- Loosen the leg length adjustment knobs and slide out the footplate
- Slide off the leg support sling by removing the two 5/16”-18 adjustment knobs
- To remove the mid axle, loosen the two attaching 1/4”-20 bolts
- To remove the backrest, remove the two attaching 1/4”-20 bolts and slide up on the backrest
- The rear suspension may be detached by removing the rear suspension tension bolt.
This bolt should be tight during use
GENERAL SPECIFICATIONS AND WARRANTY INFORMATION
Warranties
30-Day
30 DAY Money Back Guarantee
2-Year
Non-absorbent, durable U.V. resistant Phiffertex Plus brand nylon seating
material. Removable and machine washable seating. 3-ply polyurethane tires,
designed to smoothly roll across sand, dirt, grass, and another uneven
terrain
The DeBug Beach Wheelchair frame is constructed using #316L stainless steel
tubing, which is a higher grade than standard #304 marine grade stainless.
The rear caster wheels rotate 360 degrees. The wheel hubs are made from poly-
nylon material to eliminate saltwater corrosion.
The DeBug has a footrest for proper foot support.
Wheel Lock –Adjustable tension wheel brake can be actuated independently on
each side.
SPEC
Overall height (adjustable)
Width
Weight
Weight Capacity| ENGLISH (INCH)
44”-65”
33.5
40 lbs
350 lbs| METRIC (CM)
112 cm-165 cm
85 cm
18 kg
160 kg
---|---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>