Colman FB-B39 Wireless Headphones Instruction Manual
- June 5, 2024
- Colman
Table of Contents
Wireless Headphones
Instruction Manual
FB-B39
Specification
Bluetooth 5.0 Frequency：2.4 GHz
Wireless Support Protocol:
A2DP AVRCP V1.5/ HFP V1.6/ HSP V1.2
Battery: 3.7V 200 mAh
Charging Time (h)：1-2 hours
Music Time：4-5 hours
Button instruction
| Press for 5 seconds Power on when the headphone is power on, press to switch
from Bluetooth name to Radio mode
---|---
| Play / Pause Music
Answer / Hang up phone call Long press for 2 seconds to decline incoming call
| Press to move to next track
Press and hold volume up
| Press to move to Previous track
Press and hold volume down
Socket instruction
| Micro-USB Charging port
---|---
| TF card socket
| AUX socket
Instructions
Fully charge the headphone before first use.
How to charge
Connect to a USB power source using the included micro-usb charging cable
Charging
Fully Charged (approximately 2 hours)
How to Pair
When you turn the headphone on, the LED will flash blue and red to indicate pairing mode.
-
Using the Bluetooth menu on your device(phone, computer, tablet, etc.), enable searching for nearby Bluetooth devices.
-
Select” B39 ” to connect and pair.
NOTE: If your device prompts for a PIN code, enter ”0000”. -
Once paired, the LED will flash blue and you will hear a tone confirming the successful connection.
NOTE: the headphone will automatically reconnect to the last paired Bluetooth audio device when the headphone is turned on.
Play via AUX
Using the included 3.5mm auxiliary cable to connect the headphone to other audio sources including non-Bluetooth devices. Your music will automatically play.
NOTE: when wired via AUX, the Bluetooth functions are automatically
disabled. Use the controls on your source device instead.
The headphone will turn off if not connected to any Bluetooth device for 5
minutes
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
FCC ID: 2A7TE-FB-8S
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>