Azoteq IQS7222BEV01 ProxFusion Series IQ Switch User Guide
- June 5, 2024
- Azoteq
Table of Contents
Azoteq IQS7222BEV01 ProxFusion Series IQ Switch User Guide
Introduction
This user guide describes the operation of the IQS7222BEV01 Evaluation Kit. The EV-Kit consists of one part:
- IQS7222B Stamp x 1
Please note CT210A is not included in this EV-Kit.
To visualise raw data from the EV-Kit, the stamp board can be interfaced to any personal computer with USB support, along with the CT210A and the relevant IQS7222B software Graphical User Interface (GUI) available to download from the Azoteq website. The purpose of the IQS7222BEV01 EV-Kit is to help application and development engineers in evaluating these IC’s capabilities. A picture of the evaluation kit is shown below.
Setting up for the IQS7222B Stamp
To interface the IQS7222B Stamp to a PC we advise using the CT210A. This EV Kit can be setup with the following steps:
-
Download & Install GUI from Azoteq website
-
Plug the stamp board into the CT210A as shown below
-
Connect the CT210A to the PC with a USB cable (use USB data cable only)
-
Run the IQS7222B GUI (latest version available from the www.azoteq.com website)
-
Click “Start Streaming” button
-
GUI should look as follow.
Reference Designs
Support
US | Asia | South Africa | |
---|---|---|---|
Physical Address | 11940 Jollyville Suite 120-S Austin TX 78750 USA | Room 501A, |
Block A, T-Share International Centre, Taoyuan Road, Nanshan District,
Shenzhen, Guangdong, PRC| 1 Bergsig Avenue Paarl 7646 South Africa
Postal Address| 11940 Jollyville Suite 120-S Austin TX 78750 USA| Room 501A,
Block A, T-Share International Centre, Taoyuan Road, Nanshan District,
Shenzhen, Guangdong, PRC| PO Box 3534 Paarl 7620 South Africa
Tel| +1 512 538 1995| +86 755 8303 5294 ext 808| +27 21 863 0033
Email| info@azoteq.com|
info@azoteq.com|
info@azoteq.com
Visit www.azoteq.com for a list of distributors and worldwide representation.
Patents as listed on www.azoteq.com/patents- trademarks/ may relate to the device or usage of the device.
Azoteq®, Crystal Driver, IQ Switch®, ProxSense®, ProxFusion®, LightSense™, SwipeSwitch™, and the logo are trademarks of Azoteq.
The information in this Datasheet is believed to be accurate at the time of
publication. Azoteq uses reasonable effort to maintain the information up-to-
date and accurate, but does not warrant the accuracy, completeness or
reliability of the information contained herein. All content and information
are provided on an “as is” basis only, without any representations or
warranties, express or implied, of any kind, including representations about
the suitability of these products or information for any purpose. Azoteq
disclaims all warranties and conditions with regard to these products and
information, including but not limited to all implied warranties and
conditions of merchantability, fitness for a particular purpose, title
and non-infringement of any third party intellectual property rights. Azoteq
assumes no liability for any damages or injury arising from any use of the
information or the product or caused by, without limitation, failure of
performance, error, omission, interruption, defect, delay in operation or
transmission, even if Azoteq has been advised of the possibility of such
damages. The applications mentioned herein are used solely for the purpose of
illustration and Azoteq makes no warranty or representation that such
applications will be suitable without further modification, nor recommends the
use of its products for application that may present a risk to human life due
to malfunction or otherwise. Azoteq products are not authorized for use as
critical components in life support devices or systems. No licenses to patents
are granted, implicitly, express or implied, by estoppel or otherwise, under
any intellectual property rights. In the event that any of the above mentioned
limitations or exclusions does not apply, it is agreed that Azoteq’s total
liability for all losses, damages and causes of action (in contract, tort
(including without limitation, negligence) or otherwise) will not exceed the
amount already paid by the customer for the products.
Azoteq reserves the right to alter its products, to make corrections,
deletions, modifications, enhancements, improvements and other changes to the
content and information, its products, programs and services at any time or to
move or discontinue any contents, products, programs or services without prior
notification. For the most up-to-date information and binding Terms and
Conditions please refer to www.azoteq.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>