havit HV3581T-BLK Barline Wall Light Instruction Manual
- June 5, 2024
- havit
Table of Contents
Instruction Manual
Barline Wall Light Installation Instruction
Product Specifications
Model No.| HV3581T-BLK| FiV3581T-WHT| HV3582T-BLK| HV3582T-WHT| HV3584T-BLK|
HV3584T-WHT| HV3586T-BLK| FiV3586T- VHT
---|---|---|---|---|---|---|---|---
Name| Barline
Material| Aluminum + Perspex
Colour| Black| White| Black| White| Black| White| Black| White
IP Rating| IP65
Protection Class| 1 (240v Requires Earth) ****
Input Voltage| 240v AC
Lamp Base| Built-in LED
Lamp Wattage| 4-9w| 9-18w| 15-30w| 22-45w
Colour Temp| TRI Colour – 3000k, 4000k, 5500k
Lumens| 2701m, 5401m, 2901m| 5401m, 10801m, 560Im| 9001m,18001m, 9751m|
13801m, 27001m, 14951m
CRI|
80
Wiring|
Parallel
Dimmable|
No
Warranty|
3 Years Replacement’
| HV3681 Dimensions | HV3684 Dimensions |
|---|---|
| 
HV3682 Dimensions| HV3686 Dimensions
---|---
|
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation.
- Modification of this product will void any warranty.
- Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
- All o-rings and seals must be in place correctly to maintain a warranty
- This form may be updated at any time due to product improvements, please check the online installation form for the most current version.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off )
- Remove screws from the side of the fitting and set them aside.
- Install mounting bracket to wall in the desired location using appropriate screws for application.
- Connect the cable.
- Strip back the cable and connect the earth cables together first then the positive cables together. Then connect neutral cables together.
- Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. Failure to do this will void the warranty.
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Fitting is preset to 3000k, to change the slide switch located on side of the fitting to desired color temperature.
- Reattach fitting to mounting bracket making sure screws are tight to avoid any water penetration.
- Apply silicone around the edge of the fitting to prevent any water from getting inside to electrical connections.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Must be installed by a licensed electrician
| **Warranty Terms & Conditions*** | Additional Information |
|---|
|
https://havit.com.au/pages/warranty-terms-and-
conditions| https://havit.com.au/
Contact Details:
143 Beauchamp Road Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>